User's Manual

12
Step 4: Save and Restart
The Setup wizard is now completed. The new settings will be effective after the
Access Point restarted. Please click “Restart” to save the new configuration and
reboot the Access Point. If user does not want to make any changes, please click
“Exit” to quit without any changes. User also can go back to modify the setting by
clicking “Back”.
Status
This page as below shows the following information.
Firmware Version: Shows the current firmware version and released date code.
LAN: Shows the Mac address, IP address (default: 192.168.1.1), Subnet Mask,
Gateway Address. The current LAN traffic calculated in terms of number of
packets sent and received by AP through wired connection is also displayed.