User Manual

12 13

INFRAREDREMOTE CONTROL (optional):

CLPFLAT1REMOTE

Point the infrared remote control directly at the infrared sensor installed on the front of the spotlight. The maximum

range is about 8 metres. In the DMX and slave modes, the sensor of the spotlight is disabled.

BL (Blackout) / ON/OFF

The BL button is used to switch off the spotlights, regardless of the mode selected on the remote control. Pressing

the BL button once more activates the previously selected mode again.

SP (Speed)

4-Level speed setting for the colour change programs Colour Jumping (Ju) and Colour Fading (Fa). Level 1 makes

the colour change sequence run slowly. Pressing again activates Level 2 with a faster colour change sequence,

followed by Level 3 and 4, whereby Level 4 represents the fastest succession of the colour change sequence.

(Brightness)

4-Level brightness setting for the colour change programs (Ju, Fa, Au), the sound control mode (Su) and colour

macros (CM). The brightness level can be adjusted by pressing this button repeatedly.

FL (Flash / stroboscope)

4-Level speed setting for the stroboscope effect. Level 1 deactivates the stroboscope effect, Level 2 represents low,

Level 3 medium, and Level 4 the fastest ﬂash rate. The stroboscope effect can be combined with all colour change

programs (Ju, Fa, Au, Su), the colour macros (CM) and the colour mixing mode RGBWA (depending on model).

R / G / B / W / A (Red, Green, Blue, White, Amber) (depending on model)

These 5 buttons can be used to create individual colour combinations. The 4 levels of brightness can be activated

by pressing the respective colour button repeatedly, whereby at Level 1 the LEDs are switched off.

For example: If you set red and green to their respective highest level and blue and white to their lowest, i.e., off, the

result will be a bright yellow colour mix.

Ju (Colour Change)

The colour change occurs abruptly (Colour Jumping). The speed at which the colours change can be set using

the "SP" (Speed) button.

Fa (Colour blending)

Colours blend into each other (Colour Fading). The speed at which the colours change can be set using the "SP"

(Speed) button.

Au (Automatic Mode)

In this operating mode, the light switches automatically between colour change and colour blending mode. The

colour change and/or colour blending rate is determined by the settings of the respective mode.

ENGLISHDEUTSCHFRANCAIS

FRANCAISFRANCAIS

ESPAÑOLPOLSKIITALIANO