Installation Guide

V2
100 98 96 94
V2
BRAND BG - BLACK ONLY
V2
100 98 96 94
V2
BRAND BG - BLACK ONLY
36
DON’T USE
IMPACT
DRIVER
DON’T USE
IMPACT
DRIVER
MARKSMAN
MARKSMAN PRO TOOLSINTRODUCTION MARKSMAN EDGE
Setup for MARKSMAN Pro Tools
The recommended fastening speed for Edge
fastening is 2500 RPM.
Adjust the spacer teeth on the tool with the
thumb dial to fi t your board.
ADJUST DRILL ADJUST SPACER TEETH
C D
Insert the T-15 driver bit into your drill. Do not
use an impact driver.
Speed up the job by attaching the pre-drill
bit to another drill.*
INSERT T-15 BIT
IF YOU’RE PRE-DRILLING*,
INSERT THE PRE-DRILL BIT
A B
*Pre-drilling is required for capped composite and hardwoods.