Installation Guide

V2
100 98 96 94
V2
BRAND BG - BLACK ONLY
V2
100 98 96 94
V2
BRAND BG - BLACK ONLY
37
MARKSMAN PRO TOOLSINTRODUCTION MARKSMAN EDGE
How to fasten Edge Screws
MARKSMAN
PLACE TOOL DRILL HOLE* LOAD SCREWS
Place the tool on the board so it’s in line
with the joist. If you are NOT pre-drilling,
skip to step 3.
If pre-drilling, run the pre-drill bit through
both screw channels*.
*Pre-drilling is required for capped
composite and hardwoods.
Load an Edge screw into both screw
channels.
1 2 3
4
DRIVE
Drive the screw in on both sides letting the
screw do the work. The shoulder on the bit
will stop the screw from overdriving.
BEFORE YOU BEGIN
Where Edge fastening with
the MARKSMAN Pro Tools isn’t
possible, use CAMO Premium
Deck or Composite Screws. Go to
page 41 for full instructions.