NEW PRODUCTS TRAINING 2024 GUIDE
TRAINING GUIDE CONTENTS FASTENING SYSTEMS NEVER-MISS® GUIDE DRIVE MARKSMAN ® DECK CLIP FASTENING SYSTEM STAND-UP 3-IN-1 FASTENING SYSTEM HIDDEN EDGE SCREW FASTENING SYSTEM THE BETTER WAY TO FASTEN CAMO UNIVERSAL DECK CLIPS. INCLUDED IN 450 CT AND 900 CT PAILS OF CAMO UNIVERSAL DECK CLIPS. SAVE TIME WITH THE AWARDWINNING CAMO DRIVE® TOOL.
MARKSMAN 32 ® Achieve a fastener-free surface on square edge decking with this easy and affordable hidden fastening system. MARKSMAN Tools automatically establish spacing between boards and direct CAMO Edge Screws into the edge of the board, leaving a smooth deck surface. Plus, the MARKSMAN system is backed by a CAMO warranty for use in leading deck boards.
MARKSMAN® INTRODUCTION MARKSMAN PRO TOOLS MARKSMAN EDGE Get to know your MARKSMAN tools HANDLE TRIGGER SCREW CHANNEL SCREW CHANNEL THUMB DIAL TEETH SCREW CHANNEL DRIVE CONNECTION MARKSMAN PRO® MARKSMAN PRO®-X1 MARKSMAN PRO®-NB MARKSMAN® EDGE MARKSMAN tools are for exclusive use with CAMO Edge Screws WHICH TOOL SHOULD I USE? MARKSMAN PRO MARKSMAN PRO-X1 MARKSMAN PRO-NB MARKSMAN EDGE Gap 3/16 in 1/16 in 3/16 in None Board Width 5-¼ to 5-¾ in 5-¼ to 5-¾ in 3-¼ to 5 in Any Compatibl
MARKSMAN® INTRODUCTION MARKSMAN PRO TOOLS Setup for MARKSMAN Pro Tools A INSERT T-15 BIT B DON’T USE DON’T USE IMPACT DRIVER Insert the T-15 driver bit into your drill. Do not use an impact driver. C ADJUST DRILL Adjust drill to the highest speed setting. IMPACT DRIVER Speed up the job by attaching the pre-drill bit to another drill.* D ADJUST SPACER TEETH Adjust the spacer teeth on the tool with the thumb dial to fit your board.
MARKSMAN® INTRODUCTION MARKSMAN PRO TOOLS MARKSMAN EDGE How to fasten Edge Screws BEFORE YOU BEGIN Where Edge fastening with the MARKSMAN Pro Tools isn’t possible, use CAMO Premium Deck or Composite Screws. Go to page 54 for full instructions. 1 SCAN TO WATCH THE HOW-TO VIDEO 2 3 PLACE TOOL DRILL HOLE* LOAD SCREWS Place the tool on the board so it’s in line with the joist. If you are NOT pre-drilling, skip to step 3. If pre-drilling, run the pre-drill bit through both screw channels*.
MARKSMAN® Setup for MARKSMAN EDGE A ATTACH YOUR DRILL Attach the Drive Connection to your drill. NOTE: The MARKSMAN EDGE tool leaves no gap between boards. If you desire a gap, place secondary spacers before fastening.
MARKSMAN® INTRODUCTION MARKSMAN PRO TOOLS MARKSMAN EDGE How to fasten Edge screws BEFORE YOU BEGIN Where Edge fastening with the MARKSMAN EDGE isn’t possible, use CAMO Premium Deck or Composite Screws. Go to page 54 for full instructions. 1 2 3 LOAD A SCREW PLACE TOOL ON BOARD DRIVE Load an Edge screw into the magnetized screw channel. Align the screw channel with the joist, ensuring the face of the tool is flat. Tooth should be on the edge of the board.
For more information, visit camofasteners.com or contact us at 800-968-6245 or info@camofasteners.com.
