Operating instructions

CAMON-C500/11.11/14 CAMON-C500/11.11/15

CAMON C500 Stump Grinder

MAINTENANCE

For coarse adjustment, loosen

lock nuts on hub at lower end

of cable. Adjust lock nuts as

necessary and re-tighten.

For fine adjustment, turn brake

lever knob clockwise, one

revolution while brake is

released, then check operation.

Wheel should lock completely.

Repleat if necessary.

Brake Adjustment Check

WARNING

Changing Teeth

Support cutter wheel in a raised position when changing teeth!

NOTICE

Read all of the following instructions before beginning to change cutting wheel teeth.

1. Clean all dirt from the cutting wheel and teeth .

2. Remove the socket head bolts from the teeth . The ½”

hex key provided with the machine may be used.

3. Check the cutting wheel for cracks. Replace the wheel if it is

cracked.

4. Carefully select and properly position each tooth according to

diagrams.

Position teeth as shown in the cutter teeth diagram in the

Parts Section. Straight and angled teeth should be

staggered as shown in drawing.

Make sure teeth are placed in co-ordinance with wheel rotation.

After setting each tooth pair, tighten the socket head bolts to 135 to 145 foot pounds.

NOTICE

Do not hammer the tip of a tooth. Due to the super hardness of the tooth, it is brittle and

may chip from such treatment.

A “left”, a “straight”, and a “right” tooth is determined by which

direction the tip of the tooth points. The left and right sides of

the cutting wheel correspond to the left and right sides of the

machine itself, looking from the front of the machine.



LEFT

STRAIGHT

RIGHT