Operating instructions

CAMON C500 Stump Grinder
CAMON C500 Stump Grinder
CAMON-C500/11.11/2 CAMON-C500/11.11/3
1. Remove the machine from its crate.
2. Remove the handlebar securing pin - Part No
11159 (Diag No 1, Item No 1).
3. Fit the handlebar with the securing pin and fit split
pins Part No 960200 (Diag No 1, Item No 2).
4. Attach the brake cable (Diag No 2, Item No 1) and
adjust as necessary.
5. Connect the wiring harness by fitting eyelet
terminal to 6mm bolt above the on/off switch
and connect the male bullet to the black three-
way connector to the oil alert (Diag No 3).
6. Check engine oil level top up if necessary with
15w/40 oil.
7. Put unleaded fuel in the fuel tank.
8. The machine is now ready to be run in
accordance with the operating instructions.
Diag No 2Diag No 3
Diag No 1
ASSEMBLY GUIDE
Assembly Instructions
The throttle cable clamp
may be fitted in this
position. If so, move
it to the position shown
in fig. 2 (below)
This is the correct
position for the
throttle cable clamp
The throttle cable needs to be passed through
this hole to ensure full throttle during operation
FIG 1
FIG 2
READ CAREFULLY!
ASSEMBLY GUIDE
Throttle Cable Clamp
IMPORTANT
!