Operation Manual

16
CampSat Single/Twin
Equipment and cable installation
This offers a general explanation of how to install the IDU and satellite
receiver properly to the inside of vessel connecting with main cable
and coaxial cable.
1. The coaxial cable and main cable is routed from the antenna to
the IDU inside the vessel.
2. After once deciding where to place the IDU and satellite receiver,
make sure that both units are placed in a dry and protected area.
3. The IDU and satellite receiver should be placed away from any
heat source and in an area with proper ventilation.
4. Ensure that there are at least 3cm of space around both units for
ventilation and connection of cables. Do not stack the units on
top of each other.
5. Thefollowingdescribesthebasicwiringcongurationsforthean-
tenna system.
• Connect the main cable and coaxial cable to the antenna port
on the back of the IDU
• Connect one end of the supplied coaxial cable to the receiver
port on the back of the IDU
• Connect the other end of the coaxial cable to the satellite recei-
ver
Note:
•4-pin power cable
- RED Continuous positive battery (not without a vehicle security
- BLACK Mass
- YELLOW ignition plus vehicle (without fuse)
- BLACK Mass
•12-pin control cable (10m) shall not be reduced
•10m antenna cable can be adjusted in length
•1m aerial cable can be adjusted in length
Geräte und Kabelverbindung/Equipment and cable installation
Equipment and cable installation