CN-780 / CN-782 Operating Instructions
Hints Produced by IMC CAMOS GmbH Copyright © 2007 IMC CAMOS GmbH Printed in Korea All rights reserved Subject to change without prior notice. All product names might be brands or registered trademarks. All rights reserved. Reprint, nor in extracts, is not permitted without our express written approval.
Content 2 Hints 3 Content 4 Caution 4 Warning 5 Components 6 Controls 7 7 7 7 7 7 7 First Steps Power on Stand-by Battery operation DC operation Installation (Quick) Installation (Advanced, optional) 8 Launcher Menu 9 Play Back of Video Files 10 Play Back of Music 11 Photo Album 12 Play Back of an External A/V Source 13 Connecting a Rear View Camera (Option) 14 Compass 15 16 17 18 19 20 21 22 23 Settings Volume and Brightness Power Settings Start Settings Factory Settings Calib
Caution Warning WITH RESPECT TO TRAFFIC SAFETY AND LOCAL REGULATIONS YOU MAY NOT ACTIVATE THIS DEVICE WHILE DRIVING. PLEASE PREPARE DEVICE BEFORE DRIVING. PLEASE FOLLOW THE HINTS BELOW TO PROTECT YOUR HEALTH. Do not change any settings or input data while driving. Please stop or ask a co-driver to do this. As driver you must focus on traffic. ALWAYS KEEP AN OVERVIEW This product is a perfect support tool for your orientation in unknown terrain. Anyhow more important is your discernment as driver.
Components Please check, if your box is complete INSTRUCTION MANUAL Navigation System Navigation Device Manual 12V Power Cord Gosse Neck CL-9 Remote Control SD Card Navigation Software USB SD-Card Reader Multi Cable Stand CL-5 TMC Receiver (optional) Rear View Camera (optional) Illustrations might be symbolic. The functionality of the navigation software is explained in separate manual on CD/DVD.
Controls Front View ① Touchscreen: Control of the complete system ② Vertical sensor buttons: Increase/reduce volume ③ Horizontal sensor buttons: Increase/reduce brightness ④ Charge of battery: Battery completely charged Battery is charging Side Views ① AV: 3,5 mm input for Audio/Video ② RV: 3,5 mm input for rear view camera ③ RS232: ⑥ 3,5 mm serial interface ① ⑦ ③ ⑤ ④ DC12V: ② ④ For power supply 12 V DC ⑤ USB/TMC: For connection with PC or for use with TMC module.
First Steps Power on Turn on the device on the backside (ON). System will start automatically. Installation (Quick) There are different ways to install the unit in your vehicle. The easiest way is to use the goose neck with suction cup and to power the unit with the spiral cable to the cigar jack. So you may install and use the system within few minutes. HINT In case of non-usage for a longer period, it is recommended to turn off the device to avoid total discharge of the battery.
Launcher Menu After booting the launcher menu will appear. From here you may start any available function. Navigation The functionality of the navigation software is described separately. Manuals are available on CD/ DVD. Movies If an external A/V source or a rear view camera is connected, please use this function for viewing. Compass Play digital movie clips or recorded movies from SD card. Music With the help of the GPS signal you can use this function as electronic compass or speedometer.
Play Back of Video Files ① ② ③ ④ ⑤ ⑥ The Video Player enables you to play back movies on SD card. It is compatible to various formats/ codeces. Display ⑦ ⑧ ⑨ ⑩ ⑩ Exit: Return to main menu. File Listing ① Taskbar: disappears automatically at play back, pops up after touching the screen. ② ③ ④ ⑤ ⑥ / Start/pause of play back Stop Jump back to last video file. Jump forward to next video file. With the file listing you may select your video clip..
Play Back of Music ⑩ ① ② ③ ④ ⑤ The Music Player enables you to play back music files on SD card. It is compatible to various formats/ codeces. Display ① ② ③ ④ ⑤ / Start/pause of play back ⑥ ⑦ ⑧ ⑨ ⑩ RPT Select play back mode NMR Each title will be played once 1 The current title will be repeated ALL All titles will be repeated SFL Shuffle play back. File List Stop Jump back to last video file. Jump forward to next video file. With the file listing you may select your video clip..
Photo Album ⑦ ⑦ ① ② The electronic photo album is ideal for travelling or visitng friends. Various file formats are supported. Display ① Slideshow Timer: Each image will be shown for the time set. (3, 5 and 7 sec.) ② Crossfade Effects: Select one of three effects for your personal slide show.
Play Back of an External A/V Source ⑥ ① ② ③ ④ ⑤ The AV-In function enables you to watch external sources, i.e. DVD-Player, SAT-Receiver, etc. HINT Display ① AV/RV Select video input: AV AV-input RV Rear view camera input ② Mute on/off without changing the basic volume settings. ③ Rear View Camera ON/OFF If this is ON, the system will automatically switch into AV-mode, when the camera is activated. ④ Taskbar disappears automatically at play back, pops up after touching the screen.
Connecting a Rear View Camera (Option) ⑥ ① ② ③ ④ ⑤ The AV-In function can be used as full video rear view system, too Functionality Please connect the optional multicable to the device and a compatible rear view camera. (Page 25) Two different operation modes are available: 1. Camera is operated only with Rear Gear Activate ON ③ for rear view camera input and connect the red cable to the +12V supply of the back light.
Compass ④ ① ② This function shows current speed and altitude based on the GPS signal. Display ① Compass: Shows north direction ② Altimeter: Shows current altitude above sea level (Normal Null) ③ Speedometer: Shows current velocity. ④ Exit: Return to main menu. HINT These values are calculated from the GPS signal. In some cases the system requires some seconds to few minutes for getting reliable results. The velocity is an average value of the last movement.
Settings In the settings menu you can adopt the system to your personal habit. Volume / Brightness Adjust brightness and volume. Power Setting Optimize the system to get maximum power safe results. Start Setting Select the start-up application after power-on. Factory Setting Reset unit to factory settings and values. Calibration Adjust the touch screen. Time Zone Set time zone and adjust date/time. Language Select your preferred language for the unit.
Volume and Brightness ④ ①② Adjust basic volume and brightness. Display ① System Volume Use +/- for adjustment ② AV Volume Use +/- for adjustment ③ System Brightness Use +/- for adjustment ④ Exit: Return to main menu.
Power Settings ④ ① ② ③ Optimize the system to your personal usage. Display ① Timer for sleep mode Activate/deactivate the timer that can be adjusted by +/-. If you do not use the system for this time, the system will go down to sleep mode. HINT The battery lifetime depends on the usage of the system, i.e. listening to pure music, watching video or navigating. Also volume and brightness have a huge affect on power consumption.
Start Settings ④ ①② ③ Set up the start-up application of your device after a cold start. HINT Display ① Start with specific application After switching-on (ON/OFF) the selected application will be started automatically: Navigation/Music/Movie/AV-IN/Photo Album ② Start with last application After a complete re-start the device will start the last used application. ③ Start with main menu (default) The system will show main menu after reboot. ④ Exit: Return to main menu.
Factory Settings ③ ① ② Reset the device to factory settings. Display ① Set Default All values will return to default values, this will require a re-boot of the system. HINT The navigation software is not affected by this. All values and settings will remain. ② Cancel This will cancel the operation like the Exit button. ③ Exit: Return to main menu.
Calibration ② ① Please run the calibration, if you have the feeling that the touchscreen does not react exactly to your commands. HINT Display ① Blue mark Follow the instructions on the screen and touch the moving cross mark. The process wil be continued until all 5 positions are properly fixed. If finished a countdown of 5 secs will exit into menu. 20 EN This procedure cannot be cancelled and must be passed most accurately.
Time Zone ④ ① ② ③ Select your time zone and/or adjust date and time. Activate/deactivate daylight saving option. Display ① Time Zone Select your local time zone. HINT If time zone is correctly set, the internal clock will automatically adjusted by the GPS signal. Normally a manual correction is not needed. ② Day/Night Mode The system will reduce the screen brightness according to daytime. ③ Date And Time Adjustment. Use +/- for correction of the relative segment.
Language ② ① Select you preferred language. This change requires a reboot. HINT Display ① Language You may select among those seven languages. ② Exit: Return to main menu. 22 EN The navigation software is not affected by this. All values and settings will remain. Language is to be changed within the navigation software itself.
System Information ② ① This information is only needed for service and support. Display ① System informationen: Operating system and software version. ② Exit: Return to main menu.
Specification Processor Type Samsung ARM9 S3C2440A Clockrate 400 MHz SDRAM 64 MB Flash ROM 64 MB Removable Memory 2GB SD Card Type 7“ Touchscreen Resolution 480 x 234 Colours 1670 K Type SiRFstarIII™ External Antenna Optional TMC-Module Type External, optional Audio Speaker Integrated, 2x 1 Watt Connectors RV-In (Camera) 1x MiniDIN 6pin AV-In (DVD, etc.) 1x 3.
Connection Scheme Camera CM-32 (optional) 12V+ for Camera RS-232 TMC-Module (optional) 12V DC Multi Cable TIPP Connect the 12V+ wire for the camera via a switch. Thus you can enable permanent rear view by one touch.
Notes 26 EN
Notes EN 27
IMC Camos GmbH, Carl-Zeiss-Str. 7, 22946 Trittau Tel 04154 / 8083 - 0 info@imc-multimedia.
