Operation Manual

18
19
Double-sided
adhesive tape
Screw
Stand bracket
1. Please connect the stand bracket with the down-
ward and back of product.
2. After clean the installing space for Sand, please re-
move the double-sided tape at the below part of
Stand.
3. After attaching the Stand, please fix it with using
the enclosed screws.
4. After connecting Stand with the Product in the ar-
row direction, please fix it firmly as spinning the
Stand Rear Lever.
Angle control lever
INSTALLATION
8
2. STAND (CL-5)
CAMERA
GREEN (TRIGGER)
WHITE (AUDIO OUT)
RS-232 : GRAY(TX) / ORANGE(RX) / BLACK(GROUND)
RED (DC 12V~24V)
BLACK (GROUND)
USB HOST
CIGAR CABLE
CABLE CONNECTION
9
Navigation (Standard)
Navigation + Rear view
Navigation + Rear view + Telematics
CAMERA
GREEN (TRIGGER)
WHITE (AUDIO OUT)
RED (DC 12V~24V)
BLACK (GROUND)
REAR CAMERA (OPTION)
REAR CAMERA (OPTION)
FUSE 3A
FUSE 3A
1. SUCTION STAND
1. Assemble the monitor body and stand as like the picture.
2. Adjust the angle and fix it with the bolt.
3. Clean the window before absorption and fix it pulling the
lever firmly.
Stand bracket
Angle control lever
Bracket bolt
Angle control
lever
1. Please connect the stand bracket with the upward
and back of product
2. Please fix the ceiling stand with using the enclosed
screws.
3. After connecting Stand with the Product in the ar-
row direction, please fix it firmly as spinning the
Stand Rear Lever.
Stand bracket
Angle control lever
3. STAND (CL-9)