Use and Care Manual

10
Replace damaged hose assembly
before using appliance. Use only
valve/ hose / regulator specified by
manufacturer. See product sheet
for hose & regulator information.
Cleaning The Burner
NOTE: Spiders and small insects
can spin webs and build nests inside
the burner. This especially occurs
in late summer and fall before frost
when spiders are most active. These
nests can obstruct gas flow and
cause a fire in and around the burner
and orifice. Such a fire can cause
operator injury and serious damage
to the appliance. To help prevent a
blockage and ensure full heat output,
clean and inspect burner tube often
(once or twice a month). NOTE:
Water or air pressure will not
normally clear a spider web.
Steps for cleaning the Burner:
1. Remove orifice/valve from burner.
2. Look inside the burner tube for
nests, webs, or mud.
3. To remove the above obstructions,
use an accessory flexible venturi
brush or bend a small hook on
one end of a long flexible wire or
use an air hose.
4. Inspect and clean the burner
if needed.
5. Reattach orifice/hose to burner.
Cleaning and Maintenance
Correct care and maintenance
will keep your appliance operating
smoothly. Clean regularly as
determined by the amount of use.
NOTE: Clean the entire appliance
each year and tighten all hardware
on a regular basis (1-2 times a
year or more depending on usage).
Cleaning should be done where
detergents won’t harm patio, lawn,
or the like.
Suggested Cleaning Materials
Mild dish washing liquid detergent
Wire brush
Nylon cleaning pad
Hot water
Paper clip
Soft brass bristled brush
Component Cleaning:
BURNER: Wire brush loose
corrosion from burner exterior.
Clean clogged gas port holes with
an opened paper clip. Replace
corroded or damaged burners that
would emit excess gas.
COOKING SURFACES, POTS
AND PANS: Clean the cooking
surface with soapy water and a
CAUTION
All cleaning and maintenance
should only be done when the
appliance is cool and with the fuel
supply turned off at the LP cylinder.
DO NOT clean any part in a self-
cleaning oven. The extreme heat
will damage the finish.