Use and Care Manual

9
Lighting Stove with Match:
Do not lean over LP cooker while
lighting.
1. Remove all appliances from the
burner to create a free flow of air.
2. Turn regulator control valve to
OFF position.
3. Fully open LP bottle valve.
4. Light match and place it over
burner. Slowly turn ON the
regulator control valve. Do NOT
stand with head or arms over
cooker.
5. If ignition does not occur in
5 seconds, turn the burner
control(s) off, wait 5 minutes,
and repeat the lighting
procedure.
Lighting with Rotary Ignitor:
Do not lean over LP cooker while
lighting.
1. Remove all appliances from the
burner to create a free flow of air.
2. Turn regulator control valve to
OFF position.
3. Fully open LP bottle valve.
4. Turn valve to medium position.
Allow gas to flow to burner.
Immediately turn rotary ignitor.
The ignitor should spark and light
the burner.
5. If ignition does not occur in
5 seconds, turn the burner
control(s) off, wait 5 minutes, and
repeat the lighting procedures.
If built-in ignitor will not light,
follow instructions for lighting with
a match.
Curing of paints and parts will
produce an odor only on first use.
If the flame is accidentally
extinguished, turn the appliance
valves OFF and WAIT 5 minutes
before attmpting to ignite.
Burner Flame
Check
• Light burner;
rotate knob(s)
from HIGH
to LOW.
You should
see a smaller
flame in LOW position than
seen on HIGH. Always check
flame prior to each use. The air
damper mounted on the back of
your burner helps to control the
amount of primary air that mixes
with the LP gas. A blue flame with
little or no yellow flame provides
the best heat. Adjust the air
damper by turning it clockwise or
counterclockwise until the desired
flame is achieved.
Turning LP Cooker Off
• Turn all knobs to OFF position.
Turn LP tank OFF by turning
hand-wheel clockwise to a full stop.
Hose Check
• Before each use, check to
see if hoses are cut or worn.
Air Damper