Instructions / Assembly

5
4
any apartment, condominium balcony
or deck.
• Before opening LP tank valve, check
the coupling nut for tightness. When
appliance is not in use, turn off
control knob and LP tank valve on
supply cylinder.
• Never use LP tank if visibly rusted,
damaged, or out of date.
• If you notice grease or other hot
material dripping from appliance onto
valve, hose or regulator, turn off gas
supply at once. Determine the cause,
correct, clean and inspect valve,
hose and regulator before continuing.
Perform a leak test.
• The regulator may make a humming or
whistling noise during operation.
This will not affect the safety or use of
the appliance.
• Clean and inspect the hose before
each use of the appliance. If there
is evidence of abrasion, wear, cuts
or leaks, the hose must be replaced
prior to the appliance being put into
operation. See product sheet for hose &
regulator information.
• Do not block holes in bottom or sides
of appliance.
• Never operate appliance with LP tanks
out of correct position specified in
Assembly Instructions.
• Always close LP tank valve and remove
coupling nut before moving LP tank
form specified operating position.
• NEVER store a spare LP tank under or
near appliance or in enclosed areas.
• Storage of an appliance indoors is
permissible only if the cylinder is
disconnected and removed from
the appliance.
LP Tank
This grill is designed to fit Worthington,
Manchester or SMPC brand 20 lb. (9.1
kg) cylinders.
Other brand DOT cylinders may fit
this grill if the cylinder has similar
dimensions of the top and bottom rings.
The LP tank used with your appliance
must meet the following requirements:
• Purchase LP tanks only with these
required measurements: 12” (30.5cm)
(diameter) x 18” (45.7cm) (tall) with
20 lb. (9 kg.) capacity maximum.
• Be constructed and marked in
accordance with specifications for
LP tank of the U.S. Department of
Transportation (DOT) or the National
Standard of Canada, CAN/CSA-B339,
Cylinders, Spheres and Tubes for the
Transportation of Dangerous Goods.
• The propane cylinder used with this
appliance must include a collar to
protect the cylinder valve.
LP tank valve must have
• Type 1 outlet compatible with regulator
or appliance.
• Safety relief valve.
• UL listed Overfill
Protection Device
(OPD). This OPD
safety feature is
identified by a
unique triangular
in a gas grill. Flavoring chips must
be contained in a metal smoking box
to contain ash and prevent fires.
17. Never place more than 25 pounds on
the side shelf. DO NOT lean on the
side shelf.
18. After cooking, allow grill and grease
cans to cool off completely before
removing grease can.
19. Use gloves or oven mitts to hold
grease cans when moving to avoid
spilling hot grease.
• Use appliance only with LP (propane)
gas and the regulator/valve assembly
supplied with the appliance.
• Installation must conform with
local codes, or in their absence with
National Fuel Gas Code, NFPA 54/
ANSI Z223.1, or Natural gas and
proper installation code CSA B149.1
or propane and storage handling code
B149.2 Handling and storage of LP
cylinders must conform to LP Gas Code
NFPA/ANSI 58. Appliance is not for
use in or on recreational vehicle and/
or boats.
• Do not modify this appliance.
Modifications will result in a
safety hazard. Questions regarding
certification in other areas may be
addressed to 1-435-752-3922.
• Apartment Dwellers: Check with
management to learn the requirements
and fire codes for using an LP Gas
appliance at an apartment. If allowed,
use outside on the ground floor with a
10 foot clearance from walls or rails.
Do NOT use appliance on or under
INSTALLATION SAFETY PRECAUTIONS
NEVER fill the cylinder beyond 80%
full. An overfilled spare LP tank is
hazardous due to possible gas released
from the safety relief valve. Failure
to follow these instructions exactly
could cause a fire resulting in death or
serious injury.
• If you see, smell, or hear escaping
gas, immediately get away from the LP
tank/appliance and call your
fire department.
• All spare LP tanks must have safety
caps installed on the LP tank outlet.
LP Tank Removal, Transport
and Storage
• Turn OFF all control knobs and
LP tank valve. Turn coupling nut
counterclockwise by hand only – do not
use tools to disconnect. Install safety
cap onto LP tank valve. Always use cap
and strap supplied with valve. Failure
to use safety cap as directed may
result in serious personal injury and/or
property damage.
• A disconnected LP tank in storage or
being transported must have a safety
cap installed
(as shown).
Do not store an LP
tank in enclosed
spaces such as
a carport garage,
porch, covered
patio or other building. Never leave an
LP tank inside a vehicle, which may
become overheated by the sun.
• Do not store LP tanks in an area where
children play.
Safety Cap
OPD Hand Wheel