Installation & Assembly

Revised August 23, 2013

COMPONENTS AND PARTS LIST

FT-206 Austin Fountain

(5 pieces)

Pump Kit Parts List

PK500 Pump (1)

Approx. 30” of ½“ Non-Kink Black Tubing (1)

Approx. 2” of ⅝” Clear Vinyl Tubing (1)

Copper Sleeve (⅝” i.d.) (1)

4 ½” length of ½” i.d/ ⅝” o.d. Copper Pipe (1)

Copper Spiller (2)

4mm Allen wrench (1)

Wedges (3)

Hose Clamps (2)

#10 Compression Stopper (1)

Note – Hose clamps may be used for flow restrictor

FT-206A

29.5” x 18.5” x 10.25”

97 Lbs

FT-206B

12.75” x 8.5” x 16”

105 Lbs

FT-206C

14” x 10” x 8”

41 Lbs

FT-206D

5.75” x 1.75” x 4.75”

4 Lbs

FT-206E

47.5” x 23.5” x 9”

239 Lbs

NOTE: Component photos are not to scale

Fountain holds

approximately 17

gallons of water

This fountain

uses cover

FTNCOV-MED

Tools you will need

Level

4mm Allen wrench (included)

PAGE 1
FT-206 Austin Fountain (5 pieces) COMPONENTS AND PARTS LIST Revised August 23, 2013 FT-206A 29.5” x 18.5” x 10.25” 97 Lbs FT-206B 12.75” x 8.5” x 16” 105 Lbs FT-206C 14” x 10” x 8” 41 Lbs This fountain uses cover FTNCOV-MED Fountain holds approximately 17 gallons of water NOTE: Component photos are not to scale Pump Kit Parts List PK500 Pump (1) Approx. 30” of ½“ Non-Kink Black Tubing (1) Approx. 2” of ⅝” Clear Vinyl Tubing (1) Copper Sleeve (⅝” i.d.) (1) 4 ½” length of ½” i.d/ ⅝” o.d.
PAGE 2
FT-206 Austin Fountain (5 pieces) ASSEMBLY INSTRUCTIONS Revised August 23, 2013 1. Make sure you are assembling your fountain on a level surface capable of holding a minimum of 631 pounds with approximately a 7.25 square foot footprint. 2. Position the basin (FT-206E) where the fountain is to be installed, ensuring that it is level. 3. Feed the pump cord through the hole in the basin leaving enough cord length inside basin to work with the pump outside of the pump cover. 4.