Installation & Assembly

267 M

Series Bird Fountain

Revised

October 13, 2017

-WINTER CARE-

Fountain bowls/tops and other fountain components, which collect water, should not be left outside in the winter since any component,

which fills with water and freezes may crack. Likewise, components such as pedestals, which remain in a basin, filled with water,

which then freezes, may also crack or crumble. Ideally, therefore, a fountain should always be stored indoors or in a dry protected

place such as a covered porch away from the elements. However, if a fountain must be left outside:

(1) Remove pump, rubber stoppers, drainpipes, finials, and other small components for storage indoors. Note that stoppers or

drainpipes are removed to allow drainage in the event water accumulates in any basin.

(2) Raise fountain base from ground with wood strips so that base will not freeze to the ground surface.

(3) Cover or wrap the fountain with burlap or other absorbent material (old blanket or towel) and then cover securely with

plastic, making sure that water will not accumulate in the basin or other fountain component and freeze;

(4) Check fountain periodically to ensure that plastic is secure and water is not accumulating in any fountain component.

-GENERAL FOUNTAIN TIPS-

Install fountains on a level surface. You will need a properly grounded 110-volt (AC only) GFCI protected receptacle near the

fountain for your pump. All pumps are submersible and must be completely underwater to function properly. Test all pumps and

adjust to full output prior to assembly. It is not recommended that fountains be placed directly on grass or dirt. Position the channel

opening at the base of each fountain toward the electrical outlet to be used since the pump

cord will be threaded through this opening.

Check out YouTube for a “How to” video.

For more Campania product information visit www.campaniainternational.com

All of our cast stone is proudly

Pump Kit Parts List

PK80-A pump (1)

#10 M-Series stopper (1)

Approx. 8” length of 1/2” Black Non-Kink tubing (1)

Adhesive Dots (4) *

Hose clamps (1) **

* Prevents the fountain from scratching the surface it rests on.

** Hose clamps can be used as flow restrictors.

FOUNTAIN INFORMATION:

This fountain holds approximately 1/2 gallon of water.

A fountain cover is not available for this fountain.

No refill device or submersible lights are suggested for

this fountain

TOOLS REQUIRED:

Bubble Level

PUMP INFORMATION:

OEMPF75 - 75 GPH Pump

FT cord length

PAGE 1
FT-267 M-Series Bird Fountain Pump Kit Parts List PK80-A pump (1) #10 M-Series stopper (1) Approx. 8” length of 1/2” Black Non-Kink tubing (1) Adhesive Dots (4) * Hose clamps (1) ** * Prevents the fountain from scratching the surface it rests on. ** Hose clamps can be used as flow restrictors. TOOLS REQUIRED: FOUNTAIN INFORMATION: Bubble Level This fountain holds approximately 1/2 gallon of water. A fountain cover is not available for this fountain.
PAGE 2
FT-267 M-Series Bird Fountain Assemble your fountain on a level surface capable of holding a minimum of 23 pounds with an approximate 1/4 square foot footprint. FT-267B (14 lbs) 10”W x 5.5”H FT-267A (10 lbs) 8”W x 3.75”H 1. Position the basin (FT-267B) where the fountain is to be installed, ensuring that it is level. 2. Assemble the pump kit. a. NOTE: All pumps come with 1 adapter already inserted into the pump and 2 adapters secured to the power cord. i. This fountain uses the largest adapter provided.