Installation & Assembly

Tools You Will Need

Level

4mm Allen Wrench

FT-285E

16”x13.5”x15”

107lb

FT-285 Triad Fountain

(5 Pieces)

Components and Parts list

Revised July 11, 2016

FT-285A

29.75”x9”x19.25”

148lb

FT-285B

4”x4”x1”

5lb

FT-285C

30”x20.25”x9”

162lb

FT-285D

1.25”x5.25”x3.75”

2lb

Pump Kit and Parts List

Roughly 12” long 5/8” non-kink hose

Metal hose clamps(3)

300 GPH Pump(1)

Copper spiller (1)

2.8 oz Silicone (1)

Wedges(3)

4mm Allen Wrench (1)

#10 Compression Stopper (1)

This fountain uses

FTNCOV-LRG

PAGE 1
FT-285 Triad Fountain (5 Pieces) Components and Parts list Revised July 11, 2016 FT-285A 29.75”x9”x19.25” 148lb FT-285B 4”x4”x1” 5lb FT-285C 30”x20.25”x9” 162lb FT-285E 16”x13.5”x15” 107lb FT-285D 1.25”x5.25”x3.75” 2lb Pump Kit and Parts List Roughly 12” long 5/8” non-kink hose Metal hose clamps(3) 300 GPH Pump(1) Copper spiller (1) 2.
PAGE 2
FT-285 Triad Fountain (5 pieces) Revised July 11, 2016 ASSEMBLY INSTRUCTIONS 1. Make sure you are assembling your fountain on a level surface capable of holding a minimum of 500 pounds with approximately a 5 1/4” square foot footprint. 2. Place the base (FT-285E) into position where the fountain will be installed. 3. Place the basin (FT-285C) centered on top of the base. 4. See enclosed stopper assembly instructions and complete before continuing. 5.