FT-287 & 288 Falling Water 3 & 4 Fountain (6 Pieces) Revised July 13, 2016 FT-287A 7.5”x10”x25” 134lb FT-287B 4”x6.5”x1” 4lb FT-287C 7.5”x16.75”x5.5” 13lb Pump Kit Parts List PK300 Pump #10 Compression Stopper 4mm Allen Wrench 12” non-kink hose Hose Clamps (3) Wedges (3) Things you will need Level 4mm Allen Wrench This fountain uses cover FTNCOV-LRG FT-287D 1.5”x6.75”x3.25” 4lb FT-285C 30”x20.25”x9” 162lb FT-288E for FT288 only 28”x16.5”x3” 37 lb FT-286E 22.
FT- 287 & 288 Falling water 3 & 4 Fountain Revised July 13, 2016 (6 pieces) ASSEMBLY INSTRUCTIONS 1. Make sure you are assembling your fountain on a level surface capable of holding a minimum of 435 pounds with approximately a 3 square foot footprint. 2. Position the basin (FT-285C) where the fountain is to be installed, ensuring that it is level. 3. Feed the pump cord through the hole in the bottom of the base, leaving enough cord to pull the pump out of the pump cover. 4.
FT- 287 & 288 Falling water 3 & 4 Fountain (6 pieces) WINTER CARE AND GENERAL FOUNTAIN INSTRUCTIONS -W I N T E R C A R E Fountain bowls/tops and other fountain components, which collect water, should not be left outside in the winter since any component, which fills with water and freezes may crack. Likewise components such as pedestals, which remain in a basin, filled with water, which then freezes, may also crack or crumble.