Use and Care Manual

Important Safety Information

Please read and save these instructions. Read carefully before attempting to

assemble, install, operate or maintain the product described. Protect yourself

and others by observing all safety information. Failure to comply with

instructions could result in personal injury and/or property damage! Retain

instructions for future reference.

This manual contains important safety, operational and maintenance

information. If you have any questions, please visit

www.campbellhausfeld.com for customer assistance.

General Safety

• Always operate this tire inflator in an open and well-ventilated area and

not inside a confined area, such as a garage. Doing so may lead to bodily

harm or asphyxiation resulting in death.

• Do not leave the inflator unattended while the unit is running.

• Wear eye protection during the inflation process. Never exceed the

recommended pressure for any inflatable object. Do not over inflate

objects as objects may rupture/explode causing serious injury and/or

property damage.

• The air hose connector must be properly connected to secure the

inflation accessories. Use extreme caution when using inflation

accessories.

• Always put the car in park; set the emergency brake; and “chock” the

wheels before using the inflator as personal injury and/or property

damage may occur.

• Tire inflation should only be done safely away from the roadway, with

use of triangles or flares, and in compliance with the vehicle’s operating

manual.

• Always use a separate pressure gauge to check the actual pressure in

tires and in low pressure inflatable objects.

• Inflator must cool for 20 minutes after 20 minutes of continuous

operation. The inflator is not designed to operate continuously for more

than 20 minutes. Exceeding recommended run-time or not allowing for

adequate cooling will cause inflator to overheat and could damage or

destroy inflator.

• Do not use inflator on high pressure tires, such as those used on large

trucks, trailers or tractors. Inflator is programmed not to exceed 100 PSI.

• Make sure the air hose connector is properly connected to the valve

stem. Failure to properly connect the air hose will result in slower

inflation and/or no air getting to the tire.

• Inflator will get hot to the touch and may cause serious injury--do not

hold or touch while operating. Keep away from flammable materials.

MANUAL