Product Manual

Operation
IMPORTANT: Check motor rotation
before operating the compressor.
All lubricated compressor pumps
discharge some condensed water
and oil with the compressed air.
Install appropriate water/oil removal
equipment and controls as necessary for
the intended application.
Failure to install
appropriate water /
oil removal equipment may result in
damage to machinery or workpiece.
GUARDING
The
belt
guard provided must
be installed before
operating the unit.
All moving parts must be guarded.
All electrical covers must be installed
before turning on the power.
LUBRICATION
THIS UNIT
CONTAINS NO OIL.
Before operating compressor, fill
crankcase with compressor oil
according to the oil capacity chart.
Some residual oil may still be in the
pump leaving a thin coat on the sight
glass, however; there is not enough
oil to operate the unit. Fill pump with
single-viscosity, ISO100, non-detergent,
compressor oil.
Use part number ST126700AV,
compressor oil or Mobil 1
®
5W30 or
10W30 synthetic oil may also be used.
Add oil only through the oil fill plug.
Pouring oil into any other orifice will
cause oil to leak and spray out during
operation.
TF2101, TF2111, TQ3010, TQ3011, TX2101, TX2118
5
L1
L2
T2T1
X2
T2
X2
L1
L2
L3
T3
T1
Fill to the center of the sight gauge or
maximum mark on dipstick (see
Figure 5).
Using any other
type of oil may
shorten pump life and damage
valves.
Low
Max
Figure 3 - For Motor Frame Sizes
R56HZ, Y56Y or L143T.
Refer to Motor Nameplate
Motor
Ground
L3 (for 3 phase wiring only)
L2
L1
Single Phase / Three Phase
Wiring Diagram
Figure 4 - For Motor Frame Sizes 184T, 215T, 254T or 284T.
Refer to Motor Nameplate
Single Phase
Wiring Diagram
Motor
Circuit
Breaker
or Fused
Disconnect
Three Phase
Wiring Diagram
Motor
Coil
Coil
Circuit
Breaker
or Fused
Disconnect
Over
Load
Over
Load
Thermal
Unit
Thermal
Units (3)
Figure 5 - Oil Fill Diagrams
Full
Low
Sight Gauge
Oil Fill
Plug
Breather
Cap
Breather
Cap
Oil Fill
Plug
Oil
Drain
Plug
Fill
Line
Oil Drain
Plug
Drain on
side
Dipstick and
Oil Fill
Drain
Dipstick and
Oil Fill
Pressure
Switch
Pressure
Switch