Manualshelf

Use and Care Manual

ManualsBrandsCampbell Hausfeld ManualsAir Compressors, Tools & AccessoriesGet Stuff Done 3/8 in. Air Impact Wrench, Twin Hammer, Variable Speed (XT001000)
12345678910
2
BEST PRACTICES
u For best output, maintain pressure at the tool of 90 PSI.
u The longer your air hose the greater the pressure drop from compressor to tool.
If you are using a hose longer than 50 feet, consider upgrading to a 1/2 inch ID air
hose to ensure proper tool pressure.
u Failure to lubricate and maintain your air tools properly will dramatically shorten
their life. Use oil every time you use your air tool to lubricate, clean and inhibit rust
in one step. Campbell Hausfeld sells air tool oil under part number ST1270.
SPECIFICATIONS
XT001000
Maximum PSI 90
CFM under load 100% duty 3.4 CFM @ 90 PSI
CFM no load 100% duty 5.6 CFM @ 90 PSI
SCFM under load 100% duty 24.8 SCFM @ 90 PSI
SCFM no load 100% duty 40.1 SCFM @ 90 PSI
Air Compressor Recommendation 8 gallon
Max Torque 160 Ft. Lbs.
Working Torque 0 - 130 Ft. Lbs.
Rated RPM (free speed) 12,000
Impact Speed (IPM) 1,300
Variable Speed Yes
Reverse 1
Forward 3
Impact Mechanism Type Twin Hammer
Bolt Capacity 1/2 inch
Air Inlet 1/4 inch NPT (F)
Minimum Hose Size 3/8 inch
Anvil 3/8 inch
Housing Material Composite
Tool Weight 2.8 Lbs.
Tool Length 6-1/2 inches
Tool Height 6-5/8 inches
Tool Width 2-1/2 inches