User guide

05103, 05103-45, 05106, and 05305 R.M. Young Wind Monitors

7.3 Wiring

Connections to Campbell Scientific dataloggers are given in TABLE 7-1.

When Short Cut for Windows software is used to create the datalogger

program, the sensor should be wired to the channels shown in the wiring

diagram created by Short Cut.

TABLE 7-1. Connections to Campbell Scientific Dataloggers

Color

Wire Label

CR800

CR5000

CR3000

CR1000

CR510

CR500

CR10(X)

21X,

CR7

CR23X

CR200(X)

Red WS Signal Pulse Pulse Pulse P_LL

Black WS Reference

Green WD Signal SE Analog SE

Analog

SE Analog

Blue WD Volt Excit Excitation Excitation Excitation Excitation

White WD Reference

Clear Shield

7.4 Programming

This section is for users who write their own programs. A datalogger program

to measure this sensor can be created using Campbell Scientific’s SCWin Short

Cut Program Generator software. You do not need to read this section to use

Short Cut.

7.4.1 Wind Speed

For CRBasic dataloggers, wind speed is measured using the PulseCount()

instruction. Syntax of the the PulseCount() instruction is:

PulseCount( Dest, Reps, PChan, PConfig, POption, Mult, Offset )

The PConfig parameter should be set to 1 (Low Level AC) and the POption

parameter should be set to 1 (Frequency).

For Edlog dataloggers, wind speed is measured using Edlog instruction Pulse

(P3). The configuration parameter should be set to code 21 (Low Level AC,

Output Hz configuration).