User Manual

4WFB120, 4WFB350, 4WFB1K 4 Wire Full Bridge Terminal Input Modules
12: Set Active Storage Area (P80) ;Direct averaged "zero" reading
1: 3 Input Storage ;to input storage
2: 2 Array ID or Loc [ mVperV_0 ]
13: Average (P71)
1: 1 Reps
2: 1 Loc [ mVperV ]
14: If Flag/Port (P91) ;When average is calculated,
1: 10 Do if Output Flag is High (Flag 0) ;also send it to Final Storage
2: 10 Set Output Flag High
15: Set Active Storage Area (P80) ;Direct Output to Final Storage
1: 1 Final Storage
2: 11 Array ID ;set Array ID = 11 for zero data
16: Real Time (P77)
1: 110 Day,Hour/Minute
17: Sample (P70)
1: 1 Reps
2: 2 Loc [ mVperV_0 ]
18: End (P95)
19: End (P95)
End Program
5.1.3 CR7
;{CR7}
*Table 1 Program
01: 1.0000 Execution Interval (seconds)
;Other measurements could be inserted here or before the Output section
1: If Flag/Port (P91) ;On the first execution (Flag 1 is low)
1: 21 Do if Flag 1 is Low ;or when user sets Flag 1 low
2: 1 Call Subroutine 1 ;call the zeroing subroutine
2: Full Bridge (P6) ;Measure the strain gage
1: 1 Reps
2: 3 ±15 mV Slow Range
3: 1 In Card
4: 1 DIFF Channel
5: 1 Ex Card
6: 1 Ex Channel
7: 1 Meas/Ex
8: 5000 mV Excitation
9: 1 Loc [ mVperV ]
10: 1 Mult
11: 0 Offset
10