User Manual

CS475, CS476, and CS477 Radar Water Level Sensor
Subsequent Command Command Response
0D0!
Where the first zero is the sensor
address.
This is the send data command.
0+7.010<cr><If>
Where (from left to right),
0—sensor’s address;
7.010—the initial water depth value
used to calculate subsequent stage
measurements.
4.4 Step 4 — Use SCWin Short Cut to Program Datalogger
and Generate Wiring Diagram
1. Open Short Cut and click on New Program.
2. Select a datalogger and scan interval.
6