Owner's manual
Table Of Contents
- Revision and Copyright Information
- Warranty
- Assistance
- Table of Contents
- 1. General Description
- 2. Enclosure Supply Kit
- 3. Mounting Equipment Inside the Enclosure
- 4. Attachment to an Instrument Mount
- 5. When to Replace Desiccant
- 6. Resistance to Weathering
- Appendix A. Door Switch
- Appendix B. 25458/28532 DIN-Rail Terminal Kits
- Appendix C. 28960 Stack Mounting Kit
- Appendix D. Keeping Insects Out Of the Enclosure
- Campbell Scientific Companies
Appendix B. 25458/28532 DIN-Rail Terminal Kits
2. Insert the 15909 Jumpers in the terminal strips as shown in FIGURE B-4.
FIGURE B-4. 15909 Jumper installation
3. Mount the DIN-Rail bracket onto the enclosure backplate using two 505
screws and two 6044 grommets (see FIGURE B-5).
The 28532 includes three screws and three grommets. Use the
third screw and grommet to secure the 9-pin DIN-Rail at its
center.
NOTE
FIGURE B-5. DIN-Rail bracket mounted onto an enclosure backplate
B-3