HUB-SDM8 1/08 C o p y r i g h t © 2 0 0 4 - 2 0 0 8 C a m p b e l l S c i e n t i f i c , I n c .
Warranty and Assistance The HUB-SDM8 is warranted by CAMPBELL SCIENTIFIC, INC. to be free from defects in materials and workmanship under normal use and service for twelve (12) months from date of shipment unless specified otherwise. Batteries have no warranty. CAMPBELL SCIENTIFIC, INC.'s obligation under this warranty is limited to repairing or replacing (at CAMPBELL SCIENTIFIC, INC.'s option) defective products.
HUB-SDM8 Table of Contents PDF viewers note: These page numbers refer to the printed version of this document. Use the Adobe Acrobat® bookmarks tab for links to specific sections. 1. Introduction..................................................................1 2. HUB-SDM8 Specifications ..........................................1 3. General .........................................................................1 4. Installation and Wiring ................................................2 4.
This is a blank page.
HUB-SDM8 1. Introduction The HUB-SDM8 is an 8-channel hub for SDM peripherals and power connectors, and is used to daisy-chain multiple sets of SDM (Synchronous Device for Measurement) devices to a single Campbell Scientific, Inc. datalogger, as well as run multiple power connectors using a 16 AWG wire. The HUB-SDM8 is comprised of an environmental enclosure with eight compression fittings (two larger for 16 AWG power wires) and eight terminal strips.
HUB-SDM8 4. Installation and Wiring A U-bolt is used to mount the HUB-SDM8 to a 1.25 inch NPT pipe. The spring-loaded guillotines are opened with a small flat blade (2.5 x 50 mm) screwdriver (p/n 8125). Orient the screwdriver blade so that the blade edge is perpendicular to the orange separators. Gently insert the small flat blade screwdriver into the square slot located next to the circular wire port until it bottoms out.
HUB-SDM8 To CSAT3 Power To CSAT3 SDM To LI-7500 SDM To LI-7500 Power Power In SDM In SDM Out Power Out FIGURE 2. HUB-SDM8 in a Daisy-Chain Network — Bottom View 5. HUB-SDM5 The HUB-SDM8 can provide the same function as the HUB-SDM5, which is a 5-channel hub for SDM peripherals. Use the supplied plugs to seal the unused bulkhead fittings to use the HUB-SDM8 to connect multiple SDM devices to a single Campbell Scientific, Inc. datalogger.
HUB-SDM8 7. Maintenance There are no user-serviceable parts in the HUB-SDM8. Make sure that all unused bulkhead fittings are sealed with a plug and that the lid is tightly fastened.
This is a blank page.
Campbell Scientific Companies Campbell Scientific, Inc. (CSI) 815 West 1800 North Logan, Utah 84321 UNITED STATES www.campbellsci.com info@campbellsci.com Campbell Scientific Africa Pty. Ltd. (CSAf) PO Box 2450 Somerset West 7129 SOUTH AFRICA www.csafrica.co.za cleroux@csafrica.co.za Campbell Scientific Australia Pty. Ltd. (CSA) PO Box 444 Thuringowa Central QLD 4812 AUSTRALIA www.campbellsci.com.au info@campbellsci.com.au Campbell Scientific do Brazil Ltda.