INSTRUCTION MANUAL MCR1 Memory Card Reader 5/93 C o p y r i g h t ( c ) 1 9 9 3 C a m p b e l l S c i e n t i f i c , I n c .
Warranty and Assistance The MCR1 MEMORY CARD READER is warranted by CAMPBELL SCIENTIFIC, INC. to be free from defects in materials and workmanship under normal use and service for twelve (12) months from date of shipment unless specified otherwise. Batteries have no warranty. CAMPBELL SCIENTIFIC, INC.'s obligation under this warranty is limited to repairing or replacing (at CAMPBELL SCIENTIFIC, INC.'s option) defective products.
TABLE OF CONTENTS PDF viewers note: These page numbers refer to the printed version of this document. Use the Adobe Acrobat® bookmarks tab for links to specific sections. 1. INTRODUCTION ............................................................................................................................1 2. SPECIFICATIONS .........................................................................................................................1 3. OPERATING INSTRUCTIONS ...............................
This is a blank page.
MCR1 MEMORY CARD READER The MCR1 Memory Card Reader is a modified version of the CSM1 Card Storage Module. This manual only outlines the differences between these two devices, as operation is similar to the CSM1. 1. INTRODUCTION The MCR1 Memory Card Reader is designed to read and configure cards used with CSM1 Card Storage Modules. A typical application is in a data processing office where it is used to read cards sent in from one or more stations which have permanently-installed CSM1 units.
MCR1 MEMORY CARD READER the 34 to 25-pin ribbon cable provided with the PC201 card. 110/120V, 60Hz supply. The output from this transformer is 8V DC (nominal). Please refer to the CSM1 manual for further details of operation. The most relevant sections of the CSM1 manual are Section 3 (Getting Started) and Section 7 (Telecommunications). If required the adapter can be replaced by cutting the cable and connecting a battery in the range of 6-20 VDC, (e.g. a 12 V battery).
APPENDIX A. RS232 D-CONNECTOR PIN FUNCTIONS Pin Number 1 2 3 4 5 6* 7 8* Function Protective ground, internally connected to pin 7 Tx receive data line, from DTE Rx transmit data line, to DTE RTS request to send, input from DTE CTS clear to send, to DTE, normally held high by the MCR1 DSR data set ready, to DTE, held high at +5 V Signal ground DCD data carrier detect, to DTE, held high at +5 V * directly connected to the internal 5V supply, do not short to ground. 1.
This is a blank page.
Campbell Scientific Companies Campbell Scientific, Inc. (CSI) 815 West 1800 North Logan, Utah 84321 UNITED STATES www.campbellsci.com info@campbellsci.com Campbell Scientific Africa Pty. Ltd. (CSAf) PO Box 2450 Somerset West 7129 SOUTH AFRICA www.csafrica.co.za sales@csafrica.co.za Campbell Scientific Australia Pty. Ltd. (CSA) PO Box 444 Thuringowa Central QLD 4812 AUSTRALIA www.campbellsci.com.au info@campbellsci.com.au Campbell Scientific do Brazil Ltda.
