Instruction manual

CC5MPX Digital Camera

Figure 22-3 Network Configurations

At this point you can confirm or edit the IP address settings. If changes are made,

the apply button must be selected followed by Exit. Do not unplug the USB cable

or shutdown the camera at this point. The USB device must be safely removed

before unplugging the cable or shutting down the camera, otherwise the changes

will be lost.

23. Quick Notes

23.1 CC5MPX General

x The LED will flash or be on when the camera is in an Active Power State.

x When the LED is steadily on, the camera is booting up. Avoid interrupting

this process.

x Briefly pressing the setup button will always cause the camera to exit

from any low powered quiescent states and enable the Ethernet interface

for communications. The camera will remain in this state for 5 minutes.

x An active session to the camera with a web browser will prevent the

camera from entering a low powered state.

x Avoid removing power from the camera when it is in an active state. If the

camera is in an active state (LED is flashing), properly shutdown the

camera to avoid any memory card corruption before removing power. The

camera can be shut down by pressing the setup button continuously for

more than 10 seconds or by using the shutdown button on the web

interface.

x The SD memory card must be formatted to FAT32.

x If a memory card is removed from the CC5MPX to read or download its

contents, do not delete or add files manually. If it is desired to delete files

from the card, it is recommended to reformat the entire card (using

FAT32) or to use the CC5MPX web interface to delete them.

x Verify that the lens cable is properly seated, as the connector may

inadvertently become unplugged during handling or installation.