Instruction manual

CC5MPX Digital Camera
11
Refer to Table 4-2 to help determine which wires will need to be connected for
your camera application.
Table 4-2 Power & I/O Cable Wire Usage
Wire
Color
Function Connection Required
When not
Used
Black
Power Ground
Always
Red
Input Power
Always
Green
RS
-232 TX
(output)
OR
RS
-484A
The Green wire only needs to
be connected when RS
-
232 or
RS
-
485 communications are
used for PakBus or the Device
Configuration Utility.
Connect to a
grey terminal
block
White
RS
-232 RX
(input)
OR
RS
-485B
The White wire only needs to
be connected when RS
-
232 or
RS
-
485 communications are
used for PakBus or the Device
Configuration Utility.
Connect to a
grey terminal
block
Yellow
Communcation
switched power
(output)
When the camera is being used
to manage power to a
communication modem.
For solar powered sites the
camera can remove power from
the modem when
communications are not
required.
Connect to a
grey terminal
block
Blue
External trigger
(input)
When another device is being
used to trigger the camera to
capture images or video. This
can be a datalogger, a motion
sensor, or a set of contacts.
Another device can also help
keep the camera in the Fully On
Power mode by leaving the
External Trigger Input asserted.
Connect to
ground if left
in Factory
Default
settings
Clear
Shield
Always