Instruction manual

CC5MPX Digital Camera
12
4.2 Power & I/O Cable Details
The Power & I/O cable that is used for the CC5MPX camera has an outdoor
environmentally rated screw type connector on one end and discrete wire pigtails
on the other end that allow for flexible termination. When making the cable
connection to the camera the notch positions should always be lined up and care
should be taken to not cross the connector.
For information about the cable options available, see Appendix A.
x 24-AWG 3 pair (6 conductor) Individually Shielded Cables with
Santoprene Jacket
x IP-67 rated connector
x 10 inch pigtail for termination
x 3 Single Pole 16-20AWG Grey Push Operated Connector Terminals
(Figure 4-1)
x Maximum recommended cable length is 20 m (100 feet)
Longer cable lengths can be used; however, a heavier gauge of wire is suggested. It
is recommended that the individual wire resistance on the +12VDC and Ground
conductors not exceed 2.7 Ohms. Using longer cable in conjunction with RS-232
communications will require slower BAUD rates. Depending on the cable length
and type of cable, RS-232 may not be suitable for communications and the use of
RS-485 should be considered.
Figure 4-1 CC5MPX Connector Layout