Instruction manual

CC5MPX Digital Camera
14
5.1 Ethernet RJ45 Connection
The RJ45 connector on the camera is meant to interface the CC5MPX with either a
network router, cellular modem, or directly to a laptop.
If a permanent Ethernet connection is not required for an outdoor environment,
then the protective cap must be securely attached to the Ethernet connector to
provide an environmental seal.
When the protective cap is removed a standard cable with an RJ45 connector can
be used to connect the camera to another device in an indoor environment or
temporarily outdoors if weather permits.
If a permanent Ethernet connection is required outdoors or if a connection is
required in wet or harsh locations, the Environmentally Rated Ethernet Cable must
be used.
The maximum cable length for the Ethernet cable is 70 m (230 feet).
The CC5MPX does not support the PakBus communication protocol
over Ethernet.
5.2 Power I/O Connection
Connection to the Power I/O connector is necessary for camera operation and it is
the only means to supply power to the camera. The connector that connects to the
Power I/O connector provides a weather tight connection and has an IP67
environmental rating when properly connected.
When making the cable connection to the camera the notch positions should always
be lined up and care should be taken to not cross thread the connector.
5.3 Setup Button/Status LED
The Setup button is located behind a protective metal cap on the camera. The Setup
button also contains an integrated Status LED for user feedback.
To access the LED, unscrew the protective cap to expose the Button/LED. It is
highly recommended to place the protective cap back on for improved
environmental protection.
Note