Instruction manual

CC5MPX Digital Camera
25
* Disconnecting and connecting the camera to another
Ethernet device will momentarily wake up the camera to
allow it to process incoming communications. The
camera will go into the low powered mode again if no
communications occur.
Full
Power Save
Mode
* The camera is effectively off in a low powered state.
* Average power consumption is typically 10mA @ 12
VDC.
* The Ethernet is normally turned off and is only enabled
when outgoing communications are required (email or
FTP).
* User
needs to push the Stup button to temporarily
enable the camera and Ethernet port for webpage access.
* The camera can respond to RS
-232 and RS-485
communications in this mode.
Deep Sleep
Always On
* The Deep Sleep power consumption (6mA typically)
is n
ot affected by the Ethernet Power Mode.
* Ethernet, RS
-232 and RS-
485 communications are
non
-responsive in Deep Sleep state.
Moderate Power
Save Mode
* Not recommended.
Full Power Save
Mode
* The
Deep Sleep power consumption (6mA typically)
is not affected by the Ethernet Power Mode.
* If Ethernet communications are not used this can
reduce the power consumption of the camera by 50mA
when the camera exits the Deep Sleep state.
Off State
Always On
* The Off state power consumption (1mA typically) is
not affected by the Ethernet Power Mode.
* Ethernet, RS
-232 and RS-
485 communications are
non
-responsive in Off state.
Moderate Power
Save Mode
* Not recommended.
Full Power Save
Mode
* The
Off state power consumption (1mA typically) is
not affected by the Ethernet Power Mode.
*
If Ethernet communications are not used this can
reduce the power consumption of the camera by
50mA
when the camera exits the Off State.