Instruction manual

CC5MPX Digital Camera
44
Table 7-4 Power Modes
Power Mode
Ethernet
Power Save
Mode
Operating Characteristics
Fully On
Always On
* Camera is always on
* Highest power consumption
* Ethernet is on and always available for
incoming
communications
Moderate
Power Save
Mode
* Not recommended
Table text
* Camera is always on
* Average power consumption is reduced by 50mA @ 12 VDC
* The Ethernet is normally turned off and is only enabled when
outgoing communications are
required (email or FTP)
* User needs to push the Setup button to temporarily enable the
Ethernet port for webpage access
Partially On
Always On
* The camera is effectively off in a low powered state
* Typical power consumption is 80 mA @ 12 VDC
* Ethe
rnet is on and always available for incoming
communications
* The
camera will temporarily wake up to the fully on power
mode when traffic occurs on the network. In situations where
there is constant network traffic, the camera may effectively be
in the Fully On power mode
Moderate
Power Save
Mode
* The camera is effe
ctively off in a low powered state
* Typical power consumption is 80 mA @ 12 VDC
* Ethernet is always off
* Disconnecting and connecting the camera to another Ethernet
device will momentarily wake up the camera to allow it to
process incoming communications. The camera will go into the
low powered mode again
– if no communications occur.
Full Power
Save Mode
* The camera is effectively off in a low powered state
* Average power consumption is typically 10 mA @ 12 VDC
* The Ethernet is normally turned off and is only enabled when
outgoing communications are required (email or FTP)
* User needs to push the Setup button to temporarily enable the
Ethernet port for webpage access
* The camera can respond to RS
-232 and RS-485
communication in this m
ode.
Deep Sleep
Always On
* The Deep Sleep power consumption (6mA typically) is not
affected by the Ethernet Power Mode
* Ethernet, RS
-232 and RS-485 communications are non-
responsive in Deep Sleep mode
Moderate
Power Save
Mode
* Not recommended
Full Power
Save Mode
* The Deep Sleep power consumption (6mA typically) is not
affected by the Ethernet Power Mode