Instruction manual

CC5MPX Digital Camera
61
Additionally, the PakBus neighbouring address allows for communication with
devices that are several hops away on the PakBus network. See TABLE 7-11 for
reference.
Table 7-10 PakBus Communication Settings
Variable
Allowable
Values
Description
RS
-232 BAUD Rate
* 115200
* 57600
* 38400
* 19200
* 9600
Select the desired BAUD rate. Once the BAUD rate is set, it will
always be fixed. The factory Default
Settings is 115200 BAUD.
RS
-485 BAUD Rate
* 115200
* 57600
* 38400
* 19200
* 9600
Select the desired BAUD rate. Once the BAUD rate is set, it will
always be fixed. The factory Default Settings is 115200 BAUD.
PakBus Port
Read Only
The value reflects the internal jumper settings of the camera. It will
either read RS
-232 or RS-
485. See Section 8 Internal Jumpers, if the
jumpers need to be changed.
PakBus Address
1 to 4094
The desired PakBus address for this camera. The factory default is
55.
PakBus Destination
Address
1 to 4094
The PakBus address of the device the camera will communicate with
or send files to.
PakBus Neighbour
Address
0 to 4094
Enter the address of the PakBus device physically to connect to the
CC5MPX PakBus communication lines. This allows the neighbor to
relay communication between the CC5MPX and the final destination
for the data.
PakBus Communication
Delay
0 to 16
Extra delays may be required for certain communication links, such
as satellite.
PakBus
Security Code
0 to 65535
The factory default is 0. If a security code is not required by the
PakBus destination device, set this parameter to 0. Otherwise set the
security code as required by the destination service.
7.9 Still Images
Selecting the Still Image settings tab brings up the Still Image settings page (see
Figure 7-35). The Still Image settings allows for the configuration of still images
that the camera will take/
There are 2 Sub Tabs that include 2 independent Still Settings:
x Still Settings #1
x Still Settings #2
Table 7-12 Still Image Settings describes the variables used in the Still Image
settings.