Instruction manual

CC5MPX Digital Camera
65
8. Internal Jumpers
There are 2 sets of jumpers that are internal to the camera. 1 set is used to select
either RS-232 or RS-485 communications on the Power I/O cable. The other set is
used to select a pull up or a pull down resistor on the External Trigger input line.
Refer to Section 20 for details to remove the backplate to access the internal
jumpers of the camera.
8.1 RS-232/RS-485 Jumpers
Jumper locations are shown in Figure 7. There are 3 jumpers that can be moved
from either the left or the right 2 x 3 jumper posts. When the jumpers are on the
right 2 x 3 jumper posts then the RS-232 output is selected (Factory Default
position). To change the serial output format from RS-232 to RS-485 move all 3
jumpers from the right to the 2 x 3 jumper posts located on the left position.
Always move all 3 jumpers and never install additional jumpers.
The available communication interfaces can be configured with the cameras web
interface or via the Device Configuration Utility. RS-232 and RS-485 interfaces
can be configured to a range of baud rates between 9600 and 115200 baud. Both
interfaces support only the PakBus protocol.
Figure 8-1 Internal Jumper Locations
8.2 External Trigger Pull-up/Pull-down Jumper
The jumper location for the External Pull-up/Pull-down location is shown in Figure
7. When the jumper is located on the right 2 pins of the header (factory default