Instruction manual

CC5MPX Digital Camera
67
Figure 9-1 Serial PakBus Port Setting
The CC5MPX Power I/O port is configured by default to provide a 3-wire RS-232
connection (Tx, Rx, Ground). The wires can be terminated directly on the control
ports of a compatible datalogger. For connection to a computer 9 pin serial port,
use the DB9 FEMALE to Terminal Block Adaptor, which facilitates the connection
of the Cable Pigtail end to a computer 9-pin serial port. The adaptor comes with the
CC5MPX as an accessory. See Figure 9-2.
Figure 9-2 Connecting the CC5MPX to a 9 Pin RS-232 Port
An illustration of the required RS-232 connections to a datalogger is shown in
Figure 9-3.
Can be RS-232
or RS
-485