Instruction manual

CC5MPX Digital Camera
73
x Connect the camera to the serial port of a PC using the DB9 FEMALE to
Terminal Block Adaptor, as shown in Section 9 RS-232 Communications.
x Once the camera is powered up (this can typically take 90 seconds), you
should observe that the LED flashes. If the LED does not flash, you may
have to press the Setup button to exit the camera from a low powered
mode.
x Select the CC5MPX from the device list (see Figure 12-1) and connect to
the camera.
O Normally the camera is set to 115200 BAUD. If the BAUD
rate is set to something, select the appropriate BAUD rate.
x Once connected to the CC5MPX, use the tabs (see Figure 12-2) to
navigate and configure the camera.
Figure 12-1 CC5MPX Device Configuration Option