Instruction manual

CC5MPX Digital Camera
86
Figure 18-2 CC5MPX Mounting Holes
When using the optional Mounting Kit, align the outer holes of the CC5MPX with
the center hole and the 180° slot of the mount. Loosely secure the two together
with the two ¼-20 x 0.5” Hex bolts included with the kit. It is now possible to
mount the CC5MPX to either a crossarm or other mounting surface with the
included u-bolt.
With the hardware loose, the camera and the L18549 can be pivoted to allow a full
range of motion when aiming the camera. The hardware should be secured once the
camera is properly aimed at the intended target.
The focus of the camera should be checked and adjusted as required. Refer to
Section 14.2 Focus and Zoom Adjustment for details. Be sure that the lens tube is
fully seated, the sun shroud is properly oriented after the camera is aimed, and any
protective caps are properly secured.
The sun shroud can be adjusted by loosening the Philips screws and turning the
shroud. When tightening the screws back up, do not over tighten the screws as the
shroud may crack. A light torque is all that is required to hold the shroud in place.