Instruction manual

CC5MPX Digital Camera
90
Figure 19-4 Desiccant Location
20. Backplate Removal Procedures
It is necessary to remove the backplate for the following reasons:
x Access to the SD memory card
x Change internal jumper positions
x Replace desiccant
x Inspect O-rings
If the camera is powered up and operating (LED flashing), properly shutdown the
camera by holding down the setup button for more than 10 seconds continuously.
Alternatively, the Shutdown button can be used from the Live Video Homepage of
the camera. Once the LED stops flashing, remove the CC5MPX from any power
supply and disconnect any attached cabling.
To remove the backplate, start by removing the six Philips screws located along the
perimeter of the backplate (see Figure 20-1). Note that there are two washers
included with protective cover chains of the bottom cap and the RJ45 cap.
After the screws are removed, gently pull the backplate out. The backplate will still
be attached to the camera with the wires. Do no remove the wires. Pivot the
backplate to the left side of the camera. You will now have access to the inside of
the camera.
When replacing the backplate ensure that the O-ring is still seated properly on the
backplate (see Figure 19-1). This is very important as the O-ring is required to
properly seal the camera.
The backplate can only be seated in the orientation that aligns the flat surfaces of
the backplate and the bottom of the camera body. This will also help align the
screw holes. The six screws can now be threaded and hand tightened. Be sure the
two plastic washers are located between the tether chains and the backplate.
Location of
Desiccant