Specifications

CC640 Digital Camera

• *D 13:00

• 15A 15:???? – PakBus Address (prefer 1) must match the destination

PakBus address of the camera setting.

• A 01:0000 –The Max number of Nodes recommend 3 or more

• A 02:0000 –The Max number of neighbours recommend 3 or more.

• A 03:0000 –The Max number of routers recommend 3 or more.

• A 04:0000 – Default router recommend to leave at zero

12.5 CR10X Multiple Cameras

Multiple cameras can be placed on a single CR10X datalogger. However, the

system should be configured so that image transfers to the datalogger from

more than one camera do not occur at the same time. If a collision does occur,

images will not get stored onto the datalogger. Each camera attached to the

logger has to have a different PakBus, and CSDC address.

12.6 CR10X Connections

The Ext. connection is optional if the camera is set up in self-timed mode. The

CS I/O cable length between the camera and the CR10X is limited to 12 feet or

less.

Refer to 4.4 for connections to the CR10X.

13. CR1000 Interface Guide

This section contains information for interfacing the CC640 camera to the

CR1000 datalogger. The CR1000 and the CC640 both have several different

types of communication ports. This provides different interface options for the

user. This includes using the CS I/O port, the 9 Pin RS-232 Serial Port, the

control COM ports (1-4), and RS-485 if using an MD485 interface.

13.1 CR1000 Memory Setup

To facilitate the storage of images a CFM100 allows the use of a compact flash

card on the CR1000. Memory can also be allocated from the CR1000’s

internal memory to create a virtual user drive “USR:” Entering a non-zero

value for the parameter “USR: drive size” allocates internal memory for the

drive. The amount of memory required will vary depending on each

application. A good number to start with is 524288 bytes (512K bytes which is

25% of the 2M bytes available on a standard CR1000).

The following methods can be used to set the drive size of the USR:

• The Device Configuration Utility program

• PakBus Graph

• Editing the parameter from the Status Table

• The CR1000’s optional keypad and display.