Specifications

RAWS-F Remote Automated Weather Station for Fire Weather

After siting and leveling the RAWS station, open the enclosure and

(1) connect the battery cable and (2) verify the CH100 switch is in

the ‘on’ position. When this equipment is not in use (i.e.,

transport or storage), disconnect battery cable to the CH100.

NOTE

Battery

FIGURE 2-1. Inside environmental enclosure (optional equipment shown)

The RAWS Quick Deployment Weather Station comes pre-programmed,

but this program does NOT include user-specific GOES-ID parameters.

Please contact a Campbell Scientific Applications Engineer for

programming assistance. Campbell Scientific company contact

information is listed on the last page of this manual.

NOTE

TX312

GOES

Transmitter

VSP3

Vosponder

CS100

Barometric

Sensor

RF Radio

CR1000

Datalogger

CR1000 Wiring Panel

SC12

Cable

CR1000

power in

(1)

Connect

battery

(2)

Turn on

CH100

CR1000KD

packed in foam

(may go here)