Specifications

RAWS-F Remote Automated Weather Station for Fire Weather

5.5.2 Wiring, Voice Radio Interface (part #VSP3)

The Voice Radio Interface (part #VSP3) is mounted inside the RAWS

environmental enclosure and the VSP3 connections are described below.

Voice Radio Interface (part #VSP3) inside the RAWS environmental

enclosure

VSP3 “Ground” terminal contact --to-- CR1000 PC Board “G”

VSP3 “+12V” terminal contact --to-- CR1000 PC Board “+12V”

VSP3 “DATA” terminal contact --to-- CR1000 PC Board “C1”

VSP3 “RADIO” RJ45 Connector --to-- UHF/VHF Radio*

*Note: Maxon and Bendix King Radio cables are available from Campbell

Scientific.

5.5.3 Maintenance, Voice Radio Interface (part #VSP3)

There are no user-serviceable parts on the VSP3. No maintenance is required.

5.5.4 Calibration, Voice Radio Interface (part #VSP3)

No calibration is required.

5.5.5 Troubleshooting, Voice Radio Interface (part #VSP3)

If a problem with the voice radio interface (part #VSP3) is suspected, the VSP3

may be checked by measuring the +12 V and Ground terminal on the VSP3.

Acceptable readings are +11 VDC to +14 VDC. Verify the sensor wires are

securely fastened to the VSP3 connector and the CR1000 printed circuit board

wiring panel. If problems persist, try a substitute. Obtain a Return Material

Authorization (RMA) number before returning this equipment to Campbell

Scientific for repair.

5.6 CR1000 Keyboard/Display (part #CR1000KD)

5.6.1 General Description, CR1000 Keyboard/Display (part #CR1000KD)

The CR1000 Keyboard/Display (part #CR1000KD) shown in Figure 5.6-1 is

used to check datalogger status, display or plot sensor readings and stored

values, and to enter numeric data or change port/flag state. The CR1000KD is

powered from the CR1000 printed circuit board “CS I/O” connector via our

9-Pin CS I/O serial cable (part #10873) that ships with the RAWS station.

Use the CR1000KD menus to enter GOES DCP-Setup

Parameters and to select the wind speed/direction sensor on the

RAWS station. If the RAWS Quick Deployment Weather

Station does NOT have a GOES transmitter, disregard the DCP-

Setup parameters.

NOTE