CH1360 CH1390 Cooker Hood Made in China INSTRUCTION MANUAL : WWW.CAMPOMATIC.
Infor mation and advice Specifications: 220-240V ~ 50Hz 320W In certain circumstances electrical appliance may be a danger hazard. A) There shall be adequate ventilation of the room when the cooker hood is used at the same time as appliances burning gas or other fuels. B)Do not check the status of the filters while the cooker hood is operating. C)Do not touch the light bulb within half an hour after appliance use. D)Do not flambe under the cooker hood.
Know your cooker hood Please read these instructions before using your cooker hood Information Congratulations on the purchase of our Cooker hood, which is designed to include many superior features that permit you the fullest expression of your living. Before installing and/or using the cooker hood carefully read all the instructions. 1.Air duct assembly 3.Filter assembly 2.
Selection of Venting Direction Fully convertible for vertical, horizontal or ductless operation. c Du tl e C ss Information The air must not be discharged into a flue that is used for exhausting fumes from appliances burning gas or other fuels. Regulations concerning the discharge of air have to be fulfilled.
A B 2 A B 3 Vertical discharge Vertical isWe therecommend most common. that after If you select this venting direction, installation the bottom of you only need to open the knockout A.Remove the theducting hood should be no less ducting knockout by inserting a Flat head than 650mm and no more screwdriver oneabove end and thanunder 750mm theprying it up. Then snip or break theheating attanchment points by tin snips. stove's elements You mustand make sure that the ducting knockout B is burners.
Du e c tl ss C 4 Knob Ductless In a ductless installation the air is re-circulated back into the kitchen. If you do not anticipate heavy cooking this method will be preferred. It will not be necessary to remove any duct knockouts, you only need chose knockout C. You should use filters to help remove cooking odors. These filter must be washed and replaced at regular intervals. After selecting venting direction and completing installation, you can turn the knob to achieve ductless or duct.
Installation ≥650mm Ensure the power has been turned off before beginning this installation. 8 To install this hood you will require two assistants. You will need the following tools and material to complete this installation: * Drill * Flat head screwdriver * Phillips head screwdriver or cordless drill and Phillips head bit * Tin snips * 3/8″nut driver or ratchet with extension* measuring tape*hand saw or jig saw* electrical tape*duct tape 1. Remove the range hood from the carton. 2.
Security hole Key hole 9 2. Hang the hood and let it's 4 key holes aim at screws, the 4 screws should be in the narrow parts of key holes. Screws should be fasten firmly, make sure that the installation between the hood and cabinet is enough fasten. 1. According to the figure, make sure the position of hood in the cabinet. The wood strips should be line up with the 4 keyholes slots on the top of the range hood.
Information Security hole 10 If the installation surface in cabinet don't adapt to install the cooker hood, then as per FIG. 5, fix the position of cooker hood on the wall. On the wall, install 2 screws (supplied) according to the relative position of 2 key holes on the back of hood. The extent of screwing should be convenience to the next installation. Also install screws in the security holes, in case of front and back moving of hood, so that the using is safer.
Hood Using Method Turn the hood ON when cooking at high heat or when cooking flaming foods. 1. 2. Adjust the knob to be right position. Insert the power plug firmly. Information 11 Model 1: 0 1 2 3 Model 2: 12 E14 40W x 2max 13 Press the the switch of light to be on, the bulbs light on. Otherwise the bulbs don't work. When press the push button “1”or “ ”: on, the motor runs at low speed. When press the push button “2” or “ ” on, the motor runs at middle speed.
Cleaning Instructions Disconnect range hood from power supply before cleaning or servicing. 1. Cleaning the surface of hood frequently. Use mild soap or detergent to clean the hood. 2. Do not use harsh alkalis or abrasives. 3. Avoid the use of scouring powers or dishwasher compounds. 4. Grease filter may be washed using mild soap or detergent. (heavy grease build-up may not be cleaned easily and the filter may require replacement) 5.
Information 14 ·It is recommendable to clean the metallic filter every three months by carrying out the following instructions: - Remove the metallic filter from the cooker hood and wash it in a solution of water and neutral liquid detergent, leaving to soak - Rinse thoroughly with warm water and leave to dry. - The metallic filter may also be washed in the dishwasher. The metallic filter may alter in color after several washes. This is not cause for customer complaint nor replacement of metallic filter.
Cor rect Disposal of this product This marking indicates that this product should not be disposed with other household wastes throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. To return your used device, please use the return and collection systems or contact the retailer where the product was purchased. They can take this product for environmental safe recycling.
