Specification

Owners Manual
ADJUSTING FILTRATION
Filter cycles are set using a duration. Each setting can be adjusted in 1-hour increments. Filter Cycle 1 and Filter Cycle 2 are set to the same
duration.
When Filter Cycle 2 is enabled, Filter 12 will appear in the LCD. If Filter is disabled, Filter 1 will appear.
PURGE CYCLES
In order to maintain sanitary conditions, secondary Pumps and/or a Blower will purge water from their respective plumbing by running briefly
at the beginning of each filter cycle.
Configuration: Your Control Centre
WATER IS TOO HOT (OHS)
One of the water temp sensors has detected spa water temp 110°F (43.3°C) and spa functions are disabled. System will auto reset when the
spa water temp is below 108°F (42.2°C). Check for extended pump operation or high ambient temp.
FILTRATION AND OZONE
Pump 1 low and the ozone generator will run during filtration. The system is factory-programmed with two filter cycles that will run 10
minutes after power-up. The filter duration is programmable. At the start of each filter cycle, the blower (if there is one) or Pump 2 (if there is
one) will run briefly to purge its plumbing to maintain good water quality.
CLEAN-UP CYCLE
When a pump or blower is turned on by a button press, a clean-up cycle begins 30 minutes after the pump or blower is turned off or times out.
The pump and the ozone generator will run for 30 minutes or more, depending on the system. This cycle is used to clean the water within the
spa after it has been used.
TOO COLD - FREEZE PROTECTION
If the temperature sensors within the heater detect a low enough temperature, then the pump(s) and the blower automatically activate to
provide freeze protection. The pump(s) and blower will run either continuously or periodically depending on conditions.
READY-IN-REST MODE
READY/REST appears in the display if the spa is in Rest Mode and Jet 1 is pressed. It is assumed that the spa is being used and will heat to set
temperature. While Pump 1 High can be turned on and off, Pump 1 Low will run until set temperature is reached, or 1 hour has passed. After 1
hour, the System will revert to Rest Mode. This mode can also be reset by entering the Mode Menu and changing the Mode.