Specification

Owners Manual
The four White Progress Dots at the Bottom of the Screen will
advance about every minute until all four Dots are Red.
About 3-1/2 minutes after the power is turned ON, The Pump Prime
Mode Screen will be displayed. At this time the Pumps can be
manually turned On and Off. Pump Prime Mode will Auto Exit in about
4 minutes, or Press the Temp Button to Exit.
Understanding the Spa Function Icons
This Section of the User’s Manual provides Detailed Information on
the Spa Function Icons at the Bottom of the Home Page and the
Bottom of the Navigation Mode Page.
Standard Heating Mode - The Water Temp will be Checked
enery Hour, and if it is below the Set Temp, the Water will be
Heated to the Set Temp. The Water Temp will be maintained
24 hours a day.
Economy Heating Mode - The Water Temp will be Checked
during the Filter Cycles, and if it is Below the Set Temp,
the Water will be Heated to the Set Temp. The Water will Not
Heat between Filter Cycles unless the Spa is in use.
Vacation Heating Mode - The Water Temp will be Checked
during the Filter Cycles, and if it is Below 60°F, the Water will
be Heated to 60°F. The Water will Not Heat between Filter
Cycles.
Heater is ON - Flashing = Heater is is being Tested for Flow
Through the Heater and Water Level in the Heater. Heater will
turn ON shortly.
Heater is Turned OFF Today as Set in Settings>Heating
Mode>Heater Days.The Water will Not be Heated Today.
Filter Cycle 1, 2, 3, or 4 Is ON - The Filter Pump
turned ON at the Time Set and for the Duration
Set in Settings.
The Cleanup Filter Cycle is ON - One hour after the Jet Pumps
turn OFF, the Filter Pump turns ON for 2 hours to Filter the
Water.
The Spa Light is ON, or the Optional LED Spa Lights are ON.
Jet Pump 1 is On at LOW Speed.
Jet Pump 1 and Jet Pump 2 are On at HIGH Speed.
Air Blower is ON.
The Ozone Generator is ON.
Setting Up Your Spa Control System
This Section of the User’s Manual provides Detailed Instructions for
properly Setting Up your Spa Control System. All of the initial Control
System Options and Settings, like Filter Cycles and Heating Mode,
are located in the Settings Menu. In case of Power Failure, all of your
Options and Settings will be remembered by the Control System.
From the Home Screen, Touch the Select Button to change to
Navigation Mode, with the Default Settings Highlighted. Touch the
Select Button again to open the Settings Menu.
Invert the Screen - When the Screen is Inverted, the Navigation
Buttons are also Inverted, so that the Up and Down Buttons are
switched with each other and the Left and Right Buttons are switched
with each other. The Home Button does not change position. The
Screen and Navigation Buttons can be Uninverted in the same Menu.
To Invert the Screen and Navigation Buttons, in Navigation Mode; with
Settings Highlighted, Touch Select to Open the Settings Menu. With
the Invert Screen Menu Bar Highlighted, Touch Select to Invert the
Screen and Buttons.
To Uninvert the Screen and Buttons, in the Settings Menu with the
Invert Screen Menu Bar Highlighted, Touch Select again to Uninvert
the Screen and Buttons.
Set the Heating Mode - The Heating Mode determines when the
Heater will heat and how the Water Temperature will be maintained.
There’s a Description of the Heating Mode in each Heating Mode
Menu.
To Set the Heating Mode, in Navigation Mode, with Settings
Highlighted, Touch Select to Open the Settings Menu. Scroll Down ,
and with Heating Mode Highlighted, Touch Select or Right to open the
Heating Mode Menu.
Spa operation - Azure i262 CS Control Panel