Installation Guide

Imported By: CANARM LTD., 2157 Parkedale Ave., Brockville, Ontario, K6V 5V6,Tel: [phone], Fax: [phone]
INSTALLATION:
IPL394A01
05/11
QUESTIONS OR CONCERNS CONTACT CANARM AT:
1-800-265-1833 (English) 1-800-567-2513 (French)
Monday through Friday 8:00 AM to 5:00 PM E.S.T.
SAFETY PRECAUTIONS:
“ A”
“ B”
Studs
STYLE#2
Studs
“ B”
STYLE#1
1. TURN OFF ELECTRICAL POWER BEFORE STARTING INSTALLATION OF LIGHT FIXTURE.
2. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON
FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
3. CONNECT THE GROUND WIRES (BARE COPPER OR GREEN) FROM YOUR FIXTURE TO THE GROUND
WIRE (BARE COPPER OR GREEN) OR GROUND SCREW IN THE ELECTRICAL OUTLET BOX.
NOTE: Product May Not Look Exactly As Shown In Figures.
1. Refer to the mounting
bracket style that matches the
bracket that is included with your
fixture. Attach the mounting
bracket to the outlet box using
electrical box screws (not
included).
Style#1 - Loosen hex nut “A”and
“B”.Adjust stud so it clears the
fixture once assembled.Hold in
place with“A”and lock in place
with“B”.
Style#2 (Threaded holes)
Loosen“B”.Adjust stud to desired
length and lock in place with“B”
2. Screw lower downrod into
the fixture. Install swivel to the
rod, ensuring that the sleeve is at
the swivel. Tighten the locking
nut to secure rod to the fixture.
Note: Remove fixture pan, plate
and rods if required (if you wish
to change the downrod length).
Install the length of rod that is
required by threading wire
through the rod and securing it
to the fixture.
3. Connect the ground wires
(bare copper or green) from your
fixture to the ground wire (bare
copper or green) or ground screw
in the electrical outlet box.
Connect the black wire (or wire
with marking) from the fixture to
the black wire in the electrical box
and connect the white wire from
the fixture to the white wire in the
electrical box.
4. Once connections of wires
are completed, carefully tuck
wires and wire nuts into the
outlet box making sure no bare
wire (on the black and white) is
visible at the wire nuts. Install
the light fixture to the wall by
aligning the hole(s) in the
fixture with the studs or nipple
on the mounting bracket.
Secure in place with cap nut(s)
and star washer (s).
5. Remove the finishing screws
that are already on your fixture.
Position glass in place and secure
with finishing screws.
6. Install proper bulb type and
wattage (not included).
7. Insert the hanger as shown.
8. Hang the lucite.
White
Black
House supply
Ground wire
Fixture
Ground wire
TOOLS AND MATERIALS REQUIRED:
Phillips
Screwdriver
Wire Cutters
Pliers Wrench
Wiring supplies
as required by
the Canadian
Electrical Code
and/or the
Quebec
Electrical code
Shade
Fixture
Finishing
screws
socket
Bulb
x 8
x 5
x 1
Fixture
Locking
Nut
Sleeve
Rod
Swivel
Star
Washer
Fixture
S
tud
Or
Nipple
Cap
Nut
PENDAN T LIGHT