Product Manual

B-5
12/12
SAFETY PRECAUTIONS:
INSTALLATION:
1. TURN OFF ELECTRICAL POWER BEFORE STARTING INSTALLATION OF LIGHT FIXTURE.
2. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON
FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
3. FIRMLY ATTACH THE FIXTURE GROUND WIRE (BARE COPPER) TO THE MOUNTING BRACKET WITH
THE GROUND SCREW (BY WRAPPING AROUND THE GROUND SCREW) AND THEN CONNECT IT TO
THE HOUSE SUPPLY GROUND WIRE WITH A WIRE NUT.
4. WARNING: DO NOT REMOVE KNOT IN CORD (STRAIN RELIEF PROTECTION). IF CORD REQUIRES SHORTENING THEN
RE-INSTALL KNOT.
5. DO NOT ADJUST CORD LESS THAN 6” BETWEEN CEILING AND THE TOP OF THE SHADE OF THE FIXTURE.
NOTE: Product May Not Look Exactly As Shown In Diagrams. Bulbs Are Not Included.
SUSPENDED
CEILING MOUNT LIGHT
L
I
G
H
T
I
N
G
&
F
A
N
S
E
C
L
A
I
R
A
G
E
S
&
V
E
N
T
I
L
A
T
E
U
R
S
Bulb
QUESTIONS OR CONCERNS CONTACT CANARM AT:
1-800-265-1833 (English)
1-800-567-2513 (French)
Monday through Friday 8:00 AM to 5:00 PM E.S.T.
TOOLS AND MATERIALS REQUIRED:
Blade
Screwdriver
Phillips
Screwdriver
Wire Cutters
Pliers
Wiring supplies
as required by
electrical code
!
“INSTRUCTIONS PERTAINING TO RISK OF FIRE OR INJURY TO PERSONS”
“READ ALL INSTRUCTIONS”
“IMPORTANT SAFETY
INSTRUCTIONS”
“SAVE THESE INSTRUCTIONS”
“A”
“B”
“B”
Studs
STYLE#2
Studs
STYLE#1
3. Firmly attach the fixture
ground wire (bare copper) to the
mounting bracket with the ground
screw (by wrapping around the
ground screw) and then connect it
to the house supply ground wire
with a wire nut. Connect the black
wire (or wire marked “SPT-1”) from
the fixture to the black wire in the
electrical box and connect the
white wire from the fixture to the
white wire in the electrical box.
4. Once connections of wires
are completed, carefully tuck wires
and wire nuts into the outlet box
making sure no bare wire (on the
black and white) is visible at the
wire nuts. Install the light fixture to
the wall by aligning the hole(s) in
the fixture with the studs or nipple
on the mounting bracket. Secure
in place with cap nut(s) and star
washer (s).
5. Install specified bulb (not
included).
2. Attach the mounting
bracket to the outlet box using
electrical box screws (not
included).
1. Refer to the mounting
bracket style that matches the
bracket that is included with your
fixture.
Style#1 - Loosen hex nut “A”and
“B”.Adjust stud so it clears the
fixture once assembled.Hold in
place with“A”and lock in place
with“B”.
Style#2 (Threaded holes)
Loosen“B”.Adjust stud to desired
length and lock in place with“B”.
White
Black
House supply
Ground wire
Fixture
Ground wire
Star
Washer
Cap Nut
Fixture
Stud
Outlet Box
Screws (not included)
Outlet
Box
Mounting
Bracket
Imported By: CANARM LTD., 2157 Parkedale Ave., Brockville, Ontario, K6V 5V6, Tel: [phone], Fax: [phone]