Instructions / Assembly

Pg. #4
NOTE:
All set screws must be checked and
retightened where necessary, before and after
installation.
MOUNTING OPTION
INST
INST
ALLA
ALL
A
TION
TION
1.
MOUNTING BLADES TO MOTOR
7.
- Insert the blade arm into the fan as shown.
- Tighten the blade arm to motor with the screw and lock washer as shown.
- Slightly turn the blade after installation and repeat the same step for the other blades.
Fig.9
Pg. #9
DOWNROD MOUNT
-
Using a
Philips
sc
rewdriver loosen the
two
upper
jam
sc
r
ews
on
the
yoke.
-
Position down
rod inside canopy.
-
Route wir
es
exiting yoke on motor through ceiling canopy
and
down
r
od.
- Position down
r
od/canopy into
yoke and
align holes
in
yoke and
down
r
od.
- Inse
r
t bolt through
hole
in yoke and downrod.
Be
careful
not
to
damage
or
cut
the
fan wires.
- Tighten flat washe
r
, lock washer
,
and nut and bolt (not included on
some
models
).
Secu
r
e
with cotter pin through hole in the end of the
bolt.
- Secure downrod in position by tightening upper jam screws.
A
FLUSH MOUNT
- Remove the yoke screws and lockwashers which correspond to the holes
- Optional for some models -Remove rubber ring from canopy (see Fig. 2d)
in the canopy.
- Position canopy over the holes on motor and secure with the same screws
and lockwashers removed in the previous step. Ensure to place the rubber bushing
between the canopy and motor.
B
Canopy
Rubber Ring
Motor
Canopy
Yoke Screws
& Washers
Rubber Bushing
Bolt
Yoke
Jam
Screw
Bolt
Flat
Washer
Cotter Pin
Yoke
Jam
Screw
Cotter
Flat
Washer
Pin
Fig.2bFig.2a
CAUTION
Do not loosen two
lower jam screws
Fig.2c
Fig.2d Fig.2e
8.
- Remove light kit screws and washers.
- Connect polarized connectors of light kit to corresponding connectors
found in switch housing.
WARNING: BE SURE TO TURN OFF POWER
BEFORE INSTALLING
Kit
LIGHT KITS
DETACHABLE LIGHT KITS
for your model)
(Refer to one of the following light kits
Red or Blue
Wires
WhiteWires
Blackor
Blue Wires
Light Kit
Screw
Plastic Screw
Glass Panel
Fig.10a
Fig.10b
Connect - polarized connectors of light kit to corresponding connectors
found in switch housing.
- Install the light kit to the fan motor assembly by tightening 3 screws
and washers.
- Remove the 3 plastic screw from light kit.
- Install the glass panel on the light kit by tightening the 3 plastic screws.
- Screw the diffuser to the Light kit.