Instructions / Assembly

Pg.
#8
Pg. #5
MOUNTING FAN ASSEMBLY
- Place two screws and washers on mounting bracket (marked B on diagram)
which correspond with slots in canopy. Screw in two turns.
- Position canopy to mounting bracket
aligning slots to screws (marked B on
diagram) then turn to lock.
- Position and tighten the two screws and washers (marked A on diagram)
then tighten the two screws (marked B on diagram).
ENGAGE HEMISPHERE (Downrod Mount Only)
4.
5.
- Carefully rotate fan assembly until groove in hemisphere locks over tab of
canopy assembly.
NOTE: When installing fan on sloped ceiling, make sure tab on hanger bracket
faces towards the top of the slope. Depending on the slope, a longer
downrod may be required to prevent fan blades from hitting the ceiling.
WARNING: Failure to seat tab in groove could cause damage to
electrical wires and possible shock or fire hazard.
Downrod
Hemisphere
Groove
(A)
(B)
(B)
Washers
(A)
Fig.7a
Fig.7b
INSTALL MOUNTING BRACKET
- Install J-Hook through centre of outlet box and into the wooden joist.
- Secure mounting bracket and rubber gaskets to outlet box.
- Hang the safety cable onto the J-hook.
2.
WARNING: To Reduce The Risk Of Fire, Electric Shock, Or Personal
Injury, Mount To UL/CSA Listed Outlet Box Marked Acceptable for
Fan Support And Use Mounting Screws Provided With The Outlet Box.
3
3
.
.
- Hang fan on temporary hook or mounting bracket.
Ceiling
Outlet box Screws
(not provided)
Fig.3a
Tomporary
Hook
Canopy
Safety
Cable
Fig.3c
J-Hook
Safety
Cable
Canopy
Fig3b
J-Hook
Wood Joist
Outlet Box
Rubber Gasket
Mounting Bracket
Diagram Fig.3b is for Downrod Mount.
Diagram Fig.3c is for Flush Mount.
ELECTRICAL HOOK-UP
Make the following wire connections to the receiver unit (see fig. 5) using the
wire nuts supplied.
-
connect GREEN fan wire to BARE
(ground) wire.
-
connect BLACK receiver unit wire to BLACK supply wire.
- connect WHITE receiver unit wire to WHITE supply wire.
- connect WHITE receiver unit wire (MOTOR N) to WHITE fan wire.
- connect BLACK receiver unit wire (MOTOR L) to BLACK fan wire.
- connect BLUE receiver unit wire (FOR LIGHT) to BLUE light wire.
B
- After making the wire connections, ensure the wires should be spread
apart with the grounded conductor and the equipment-grounding
conductor on one side of the outlet box and the ungrounded conductor
on the other side of the outlet box.
- This fan is equipped with a remote control unit for controlling the fan
speeds and light kit.
A
Setting the code on the hand-held remote and
the receiver.
- remove the battery cover on the hand-held
remote (Press firmly below the arrow and slide
the battery cover off).
- set code switches to desired position.
- set the code switches to the same positions on
the receiver as set on the remote.
Fig.4
-
connect the male and female plug from the filter and the receiver.
- Ensure the splices after being made should be turned upward and
pushed carefully up into the outlet box.
MOUNT BLADE BRACKETS TO BLADES
6.
- Place blade bracket screw through flat washer, fibre washer and blade.
- Align with corresponding hole in blade bracket.
- Repeat with (2) remaining screws and tighten.
Blade
Bracket
Fibre Washer
Flat Washer
Blade Bracket Screw
Fig.8