Installation Guide

1. Screw the centre rod to
the fixture.
2. Install the length of rod
that is required by threading
wire through the rod and
screwing it to the fixture.
Install swivel to the rod,
ensuring that the sleeve is at
the swivel.
3. Screw the 4 nuts on the
cables into the screw stud as
shown.
4. Adjust the height of the
fixture by pushing the
button.
QUESTIONS OR CONCERNS CONTACT CANARM AT:
1-800-265-1833 (English) / 1-800-567-2513 (French)
Monday through Friday 8:00 AM to 5:00 PM E.S.T.
TOOLS AND MATERIALS REQUIRED:
SAFETY PRECAUTIONS:
Phillips
Screwdriver
Wire Cutters
Wiring supplies
as required by
electrical code
1. TURN OFF ELECTRICAL POWER BEFORE STARTING INSTALLATION OF LIGHT FIXTURE.
2. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE
BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE
HAZARDS INVOLVED.
3. CONNECT THE GROUND WIRES (BARE COPPER OR GREEN) FROM YOUR FIXTURE TO THE GROUND
WIRE (BARE COPPER OR GREEN) OR GROUND SCREW IN THE ELECTRICAL OUTLET BOX.
Pliers Wrench
L
I
G
H
T
I
N
G
&
F
A
N
S
E
C
L
A
I
R
A
G
E
S
&
V
E
N
T
I
L
A
T
E
U
R
S
!
INSTRUCTIONS PERTAINING TO RISK OF FIRE OR INJURY TO PERSONS
READ ALL INSTRUCTIONS
IMPORTANT SAFETY
INSTRUCTIONS
SAVE THESE INSTRUCTIONS
INSTALLATION:
Imported By: CANARM LTD., 2157 Parkedale Ave., Brockville, Ontario, K6V 5V6, Tel: [phone], Fax: [phone]
CHANDELIER
Fixture
rod(s)
Center rod
2
2
2
3
3
4
Canopy
Joint
1
“B”
Studs
Outlet Box Screws
(not included)
Outlet
Box
Mounting
Bracket
White
Black
House supply
Ground wire
Fixture
Ground wire
Star
Washer
Cap
Nut
Fixture
Stud
5. Loosen “B”. Adjust stud to
desired length and lock in place
with “B”
6. Mount the mounting bracket
to outlet box using outlet box
screws (not included). Make sure
the studs on the mounting bracket
are facing out from the outlet box.
7. Connect the ground wires
(bare copper or green) from your
fixture to the ground wire (bare
copper or green) or ground screw
in the electrical outlet box.
Connect the black wire (or wire
with marking) from the fixture to
the black wire in the electrical box
and connect the white wire from
the fixture to the white wire in the
electrical box.
8. Once connections of wires
are completed, carefully tuck
wires and wire nuts into the
outlet box making sure no bare
wire (on the black and white) is
visible at the wire nuts.
9. Position fixture over studs on
mounting bracket assembly.
Secure fixture in place with star
washer(s) and cap nut(s).
10. Install proper bulb type
and wattage (not included).
Bulb
NOTE: Product May Not Look Exactly As Shown In Figures.
ICH576A05XXX26
08/15