Installation Sheet

4. Once connections of wires are
completed, carefully tuck wires and
wire nuts into the outlet box making
sure no bare wire (on the black and
white) is visible at the wire nuts.
5. Secure the pan to the nipple
tightening by star washer and hex nut.
Screw the finial to the nipple.
6. Position glass on the fixture
and push into place. Insent the
decorative cup onto the socket.
7. Install specified bulb type and
wattage (not included).
SAFETY PRECAUTIONS:
ICH633A08
10/15
CHANDELIER
1. TURN OFF ELECTRICAL POWER BEFORE STARTING INSTALLATION OF LIGHT FIXTURE.
2. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON
FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
3. CONNECT THE GROUND WIRES (BARE COPPER OR GREEN) FROM YOUR FIXTURE TO THE GROUND WIRE (BARE
COPPER OR GREEN) OR GROUND SCREW IN THE ELECTRICAL BOX.
Nipple
Hex Nut
Electrical Box
Electrical Box Screws
(not included)
Mounting
Bracket
1. Attach the mounting bracket
to the outlet box using electrical
box screws (not included) . Attach
the nipple to the mounting bracket
and adjust until it will clear the
canopy when assembled (Place the
canopy over the nipple and tighten
the upper connector onto the
nipple until snug. The upper
connector should hold the canopy
snug to the ceiling). Lock the nipple
in the correct position using the
hex nut.
2. Spread one end of chain
open and fasten the upper loop.
Hang the chain to the upper loop
and close the opening. Repeat the
same for another chain connection.
Feed the cord and ground wire
through the chain and the upper
loop.
3. Connect the ground wires
(bare copper or green) from your
fixture to the ground wire (bare
copper or green) or ground screw
in the electrical outlet box.
Connect the black wire (or wire
marked “SPT-1”) from the fixture to
the black wire in the electrical box
and connect the white wire from
the fixture to the white wire in the
electrical box.
TOOLS AND MATERIALS REQUIRED:
Phillips
Screwdriver
Wire Cutters
Pliers Wrench
Wiring supplies
as required by
the Canadian
Electrical Code
and/or the
Quebec
Electrical code
!
INSTRUCTIONS PERTAINING TO RISK OF FIRE OR INJURY TO PERSONS
READ ALL INSTRUCTIONS
IMPORTANT SAFETY
INSTRUCTIONS
SAVE THESE INSTRUCTIONS
Hex
Nut
INSTALLATION:
Imported By: CANARM LTD., 2157 Parkedale Ave., Brockville, Ontario, K6V 5V6, Tel: [phone], Fax: [phone]
L
I
G
H
T
I
N
G
&
F
A
N
S
E
C
L
A
I
R
A
G
E
S
&
V
E
N
T
I
L
A
T
E
U
R
S
QUESTIONS OR CONCERNS CONTACT CANARM AT:
1-800-265-1833 (English) / 1-800-567-2513 (French)
Monday through Friday 8:00 AM to 5:00 PM E.S.T.
NOTE: Product may not look exactly as shown in figures.
Glass
Fixture
Socket
Decorative
Cup
Bulb
Nipple
House
supply
ground
wire
Star
Washer
Finial
White
Black
Fixture
Ground wire